How do I reset my iHome radio?

How do I reset my iHome radio?

To do so, turn the unit ON and press the end of paperclip or similar into the reset port on the back of the unit for less than 2 seconds to reset it without clearing Bluetooth settings. The unit will reset and power back on. (If pressed for longer than 2 seconds, the unit will reset but will not power back on.)

Why does my iHome have a flashing battery?

The iP90 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries.

How do you use the iHome dock?

Insert the iPod and iPhone into the dock on top of the iHome. Some iHome devices have two docks, allowing you to charge an iPod or iPhone at the same time. Turn the iHome on and insert the iPod or iPhone into the desired dock. Sync the iPod or iPhone to the iTunes library on your computer.

How do I set the time on my iHome iP90?

Press and hold “Clock Button” for 2 seconds. Press and release “Alarm 1 or 2 button” to select 12 or 24 hour display. Press clock button again (or no button within 10 seconds) and the settings are automatically saved.

How do I reset my iHome dock?

Reset your iHome unit Leave the unit for about 15 minutes to ensure that all electronic charges have dissipated from the unit. Replace batteries and reconnect to power source. For units with a reset port or button, press the reset button or insert a paper clip or similar into the reset port then release/remove.

Why is my iHome speaker not connecting?

If your device does not auto-link when within range, re-pair the device. To do so, first delete this unit from your Bluetooth devices menu. Move the Power OFF/Bluetooth/Aux Switch on the unit to the Bluetooth position (center) to begin pairing. Check your device’s manual for details on Bluetooth pairing and linking.

How do I set the alarm on my iHome dock?

1. Press and hold the Alarm 1 Button for 2 seconds until the alarm time flashes at the bottom of the display. 2. Press the – or + Buttons to adjust the display to the desired alarm time (hold for rapid setting).

How do I set my iHome?

Press and Hold the Time Set Button located on the back of the unit until the display flashes. Press the – or + Buttons to adjust the clock to the current time (hold for rapid setting). Make sure you set the correct AM/PM time.

How do I set my iHome radio station?

How to Set FM Stations?

1. Press and release the Mode Button as needed until the FM indicator icon appears on the display.
2. Press the – or + Buttons to tune the radio to the desired station (hold to scan for the next clear station).
3. Press and hold the Play/Pause Presets Button to enter Preset setting mode.

How do I charge my iHome docking station?

Charging a Device with the USB Port A 1 Amp USB port is located on the back of the unit for charging devices while the unit is connected to AC power. Connect one end of a compatible USB cable (not included) into the standard USB port on the unit and the other end into the device you wish to charge.

How do I change the time on my iHome iplwbt5?

Press and release the Time Sync Button. “CLOCK SET” will appear on the display and the time will flash. Press the + or – Buttons to set the correct time (hold for rapid adjustment).

How do I change the time on my iHome hbn20?