Can you replace a Hunter fan remote?

Can you replace a Hunter fan remote?

If you have lost or broke your ceiling fan remote control there are many different replacements available. Whether you have a Hunter Ceiling Fan, Hampton Bay Ceiling Fan or Harbor Breeze Ceiling Fan, you can find remote control replacements that will work with your fan.

Why is my Hunter fan remote not working?

If you noticed that your ceiling fan remote control is not working, then you must find the cause for this malfunction. Turn the switch on the wall for five seconds and then try turning it back on to change the settings on the dip on the remote control receiver. This should be enough for the remote controller to work.

Are all Hunter fans remote compatible?

Hunter fans that come with pull chains are compatible with either a handheld remote or a wall control that mounts inside the wall switch. Our most popular handheld remote is the 99122 and most popular wall control is model 99375. Each of these models includes the receiver unit as well.

Will ceiling fan work without remote?

Things You’ll Need To control a remote-controlled ceiling fan without using the remote, add a pull cord to the pull switch on the motor module. The pull cord can be purchased from a hardware store or garden and patio shop, while the tools needed are already in most households.

How do I reset my Hunter fan remote?

Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Press and hold both the ‘FAN’ and ‘LIGHT’ buttons for at least four seconds. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.

Who owns Hunter fan Company?

Three years later, Hunter was acquired by Robbins & Meyers, Inc., a fan manufacturer based in Springfield, Illinois. For the next 45 years, Hunter operated as a wholly owned subsidiary of Robbins & Meyers, producing a complete line of residential, commercial, and industrial fans.

How do you remote reverse a Hunter fan?

How to Reverse a Hunter Fan

1. Press the “Reverse” button on the remote control of the ceiling fan to change the direction of the airflow. Press the “Reverse” button again to revert to the previous direction of airflow.
2. Turn the fan off. Locate the reversing switch.
3. Slide the switch to the opposite side. Turn the fan on.

Why is my Hunter ceiling fan not working?

Another possible cause is when a fan is wired to a dimmer switch. If the noise is more like a buzz then it could be a capacitor that has failed although this is rare as Hunter use very high quality capacitors. If the fan is really old then it could also be motor laminates breaking down.

How do I wire a hunter ceiling fan?

Connect the ground wire from the ceiling fan (often this is connected to the fan’s hanger bracket) to the circuit ground wire and to the electrical box (if it is metal), using a pigtail wire to connect to the box. Join the three wires with an appropriately sized wire connector. Secure the pigtail wire to the box with a grounding screw or clip.

How do you program Hunter Douglas remote?

Straighten out a paper clip and stick it into the small hole on the back of the Hunter Douglas PowerRise remote control. The LED light on the front of the remote control will blink green for approximately 30 seconds, indicating the remote is ready for programming.

How do you troubleshoot a hunter ceiling fan?

In terms of troubleshooting a Hunter ceiling fan remote control, much of the troubleshooting will be similar to troubleshooting other fans: Turn power on to the fan. Try using the remote to turn on the fan. If you cannot get the fan to turn on at all using the remote, pull on the pull chain and set the fan to the highest speed.