How do you change the oil on a Tuff Torq K46?

How do you change the oil on a Tuff Torq K46?

Support K46 with jack.

1. Remove the bolt (13mm) on. the front right side of the K46 to the mounting bracket. Remove the 4 bolts (13mm)
2. Remove the magnet from the fill hole – it is the shape. of a coin and standing on end.
3. Let it drain. Refill the K46 with new 5W50 synthetic motor oil (takes.

What fluid goes in a Tuff Torq K46?

Tuff Torq recommends using only using approved Tuff Tech drive fluid when servicing any of our transaxles. Only use the fill port (covered by the black cap) to refill unit. You will need approximately 2.2 liters of oil to properly refill the unit if completely empty.

Is Tuff Torq K46 good?

The Tuff Torq K46 is the most popular integrated hydrostatic transaxle (IHT) in the world…and for good reason. This power unit has all the features and performance of much larger and more expensive transaxles, all at a very affordable cost and in a small and purpose-focused design.

How much oil does a transaxle hold?

Note: On transaxles, keep the vent plug open until the oil is filled to mark. Fill the reservoir with recommended fluid (about 2 quarts per transaxle on XL, HD, Max Zoom, ProTurn, PT100, & Compacts) (5 quarts per transaxle on PT 200 & 400 models using ZT-5400 transaxles). 1. Remove the cap from the expansion tank.

Is the K46 Transmission good?

The K46 is the most popular integrated hydrostatic transaxle (IHT) in the world…and for good reason. This transaxle has a proven track record in a vast array of applications in all kinds of conditions. We are confident that the K46 is a great choice for your next riding mower or lawn tractor project!

How do you purge a Husqvarna hydrostatic transmission?

After the engine is running, move throttle control to slow position. With motion control levers in neutral (N) position, slowly disengage clutch/brake pedal. Step 4-Move motion control levers to full forward position and hold for five (5) seconds. Move levers to full reverse position and hold for five (5) seconds.

How do you put fluid in a Husqvarna hydrostatic transmission?

Slide the transmission oil drain pan from under the transmission oil filter. Fill the hydrostatic transmission oil filter reservoirs with new hydrostatic transmission oil. Pour the transmission oil into the reservoirs by hand. Fill the oil reservoir to the full line that is embossed on the side of the reservoir tank.

When to change oil in tuff Torq K46?

In heavy usage applications, oil changing is recommended after the 1st 50 hours of operation and every 200 hours, thereafter. The filter should never require changing unless the transaxle is removed from the tractor or rider and opened for repairs.

When to change oil in a K46 transaxle?

Changing & Checking Oil in the K46 w/ext. reservoir housing (ex.K46AM) An oil change schedule is suggested to extend the life of the K46 transaxle. Tuff Torq recommends changing oil after the 1

Where do you refill a tuff Torq transmission?

Invert transaxle to allow oil to drain from case through the port under black cap. Refill transmission case with oil through same port to near top of case. Tuff Torq® recommends refilling transmission with Tuff Torq® hydrostatic oil, available from our service and aftermarket department.

How much oil to use on Tuff Torq transaxle?

Tuff Torq recommends using only using approved Tuff Tech drive fluid when servicing any of our transaxles. Only use the fill port (covered by the black cap) to refill unit. You will need approximately 2.2 liters of oil to properly refill the unit if completely empty.