How do you score a set of deer antlers?

How do you score a set of deer antlers?

1. Step 1: Measure the inside spread.
2. Step 2: Measure tine length on one side.
3. Step 3: Measure the circumferences on one side.
4. Step 4: Measure the main beam length on one side.
5. Step 5: Repeat on the other side.
6. Step 6: Measure any abnormal points.
7. Step 7: Add and subtract.

How long does a point have to be on a buck to count?

one inch
Number of points on each antler. To be counted a point, a projection must be one inch long and its length must exceed the length of the base. All points are measured from tip of point to nearest edge of beam as illustrated. Beam tip is counted as a point but not measured as a point.

Is it illegal to take antlers off a dead deer?

“People kind of have an obsession with deer antlers, so therefore they’re cutting heads off or cutting the antlers off,” state wildlife officer Jason Keller said. “All of that is illegal, unless they do have a piece of paper that says that they legally acquired them.

Is there an app to score deer?

Holding two U.S. issued patents, BuckScore® is the only science-proven program that allows you to score pictures of bucks in minutes. Winner of numerous whitetail science accolades and awards, the app allows deer hunters to know the score of every deer they pursue.

How rare is an 8 point buck?

Studies show that 8-point bucks are the most common, making up 50 percent of antlered deer in all mature buck age classes.

How do you tell the points on a deer?

So just count the standing normal points on the main beam to quickly determine the number of points. A buck with two standing normal points per side is an 8-pointer, one with three standing points is a 10-pointer, and so on.

How do you score a deer antler rack?

Take the measurement from the front of the antlers. Write down all your measurements on your score sheet or using the Boone and Crockett Club online form. This is usually a small measurement because the main beams reach toward each other in the middle of the rack.

How to score a whitetail deer step by step?

Scoring whitetail deer – How to score a buck Measure the main beams of the antlers This measurement is taken on the outside edge of each antler, starting at the base of the burr. From the base of the burr, follow the outside and center of the main beam all the way to the antler tip.

How are the points written on a deer antler?

The Boone and Crockett Club scoring sheet has places for up to seven points, although few deer will have that many. Repeat with the points on the left antler. Each point will have a separate box in which to write the measurement. Determine the circumference points for your antlers. This is the narrowest point between one location and another.

When do you take measurements of deer antlers?

(Note: A flexible steel cable can be used to measure points and main beams only.) Enter fractional figures in eighths, without reducing. Official measurements should not be taken until the antlers have air dried for at least 60 days after the deer was killed. Enter measurement 32 1/8″ as Spread Credit Right Antler Left Antler Deductions