How do I reset my Linksys WRT120N router password?

How do I reset my Linksys WRT120N router password?

How to Reset the WRT120N Password

1. Turn the router around so you can see the plugged-in cables and the red Reset button.
2. Use a paperclip or pin to press the Reset button for approximately 5 seconds.
3. Remove the power cable from the back of the WRT120N for a few seconds, then plug it back in.

How do I connect my Linksys WRT120N?

How to Manually Set a Linksys WRT120N Wireless Router (13 Steps)

1. Disconnect the modem from its power source, and then connect one end of an Ethernet cable to the “Internet” port on the back of the router.
2. Connect the other end of the cable to the “Ethernet” or “1000BASE-T” port on the rear of the modem.

How do I reset my Linksys WRT120N?

Hold the reset button with the power on, for 30 seconds, then while continuing to hold the reset button, unplug the Linksys router, continuing to hold the reset button for 30 seconds, and while still holding it in, plug in the power again and keep holding the reset button for an additional 30 seconds.

How do I setup my Linksys WRT120N as a repeater?

How to Configure a Linksys Wireless Repeater

1. Connect to the wireless network.
2. Click “Wireless,” and then “Basic Settings.” Write down the name of the network (sometimes referred to as the service set identifier).
3. Click “Wireless Security” and then write down the security mode, encryption method, and pre-shared key.

How do I reset my Linksys wireless N router?

Locate the Reset button and, using a pen or a paper clip, press and hold the Reset button for 10 seconds. QUICK TIP: For router models such as the Linksys Wireless-B and Wireless-G routers, press and hold the Reset button for 30 seconds. QUICK TIP: Observe the Power light of the router while pressing the button.

What is Linksys admin password?

admin
Linksys routers use “admin” as the default administrator password.

How do I find my Linksys router password?

Checking the Linksys Wi-Fi Router’s name and Password

1. Launch Linksys Connect on the computer that was used to set up the Linksys Wi-Fi Router.
2. On the Linksys Connect main screen, select Router settings.
3. The Router name and Password are found under the Personalize section.
4. Launch a web browser like Internet Explorer.

Which is the IP address for Linksys wrt120n?

Search Home Linksys WRT120N Linksys – WRT120N Default username, password, ip… User name Password Description admin show me! Default ip address: 192.168.1.1 No password

What is the default password for a Linksys router?

Like most Linksys routers, the Linksys WRT120N default password is admin. Although some routers require a default username that must be entered along with the password, the WRT120N username field can be left blank; only the password is required. Information in this article applies specifically to the Linksys WRT120N router.

What to do if you can’t log in to your Linksys router?

If you can’t log in to the Linksys WRT120N with the default credentials, reset the router to reapply the default settings and reinstate the admin default password. To reset a Linksys WRT120N router: Turn the router around so you can see the plugged-in cables and the Reset button.

Where is the reset button on a Linksys router?

Here’s how to reset a Linksys WRT120N router: The Reset button is at the back of the router, so turn the whole thing around so you can see all the plugged in cables. Using a small object, like a paperclip or pin, hold down the Reset button for 10-15 seconds.