How do you test an ignition module on a Sportster?
How do you test a Harley ignition module?
- Turn off the motorcycle. Allow the engine to become cool to the touch before proceeding.
- Disconnect, by hand, the two spark plug wires from the coil.
- Set the ohmmeter to read resistance on the “Rx1” setting.
- Set the ohmmeter to read resistance on the “Rx1000” setting.
What is an ignition module?
the ignition module is responsible for firing the spark plugs. each spark plug must fire at exactly the right time for the engine to run properly. the ignition module uses input from the crankshaft position sensor or camshaft position sensor to determine when to fire the spark plugs.
How much horsepower does a stock 883 Sportster have?
53.00 HP
| Harley-Davidson Sportster 883 Engine and Transmission Technical Data | |
|---|---|
| Camshaft Valvetrain Configuration | – |
| Maximum power – Output – Horsepower | 53.00 HP (38.7 kW) @ 6000 RPM |
| Maximum torque | 67.00 Nm (6.8 kgf-m or 49.4 ft.lbs) @ 4400 RPM |
| Engine Maximum RPM | – |
How do you test an ignition control module with a multimeter?
Place the red lead of the multimeter on the positive coil terminal. Place the black lead to the battery negative terminal. Turn on the ignition switch to the “Run” position. The multimeter should read battery voltage at the positive terminal.
Where is the ignition control module?
distributor housing
Typically the Ignition Control Module is located inside of the distributor housing or mounted on the side of the engine compartment.
How much does it cost to replace ignition module?
Ignition Control Module Replacement Cost – RepairPal Estimate. Labor costs are estimated between $57 and $71 while parts are priced between $221 and $313. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How many miles per gallon does a Harley 883 get?
51-mpg
The gas tank has a 3.3-gallon fuel capacity and a 51-mpg fuel economy. The 2020 Harley-Davidson Sportster Iron 883 is a great bike for those just entering the motorcycle world and for those looking for a city joyrider.
How do you diagnose ignition problems?
Here’s How To Diagnose Your Ignition Issues
- Verify Lack of Spark.
- Check for Any Obvious Issues.
- Probe for Power.
- Double-Check Firing Order.
- Double-Check Initial Timing.
- Test/Inspect Spark Plugs.
- Test Spark Plug Wires.
- Check for Spark at Coil.