How do I reset my Dlink DIR-505?

How do I reset my Dlink DIR-505?

Step 1: While the router is on, use the end of a paper clip to press the button inside the pinhole on the underside of the router, as highlighted by the red circle below. Step 2: Hold the button down for 10 seconds and then release. Step 3: The unit will reboot automatically.

How do I factory reset my DIR 857?

Step 1 – While the router is powered on, insert the end of a paper-clip into the pinhole on the back of the router, as highlighted below. Step 2 – Holdthe paperclip down for 10-12 seconds, then release. Step 3 – The router will automatically reboot. Once the WLAN light stops blinking, the unit has been reset.

What is DLink default Admin password?

Step 1: Open your web browser and enter http://dlinkrouter or http://dlinkrouter.local or http://192.168.0.1 into the address bar. The default username is Admin and the password is blank (nothing). Click Login. Step 4: Scroll down the page to “Wireless Security Mode”.

How do I update firmware on my DIR 505?

How to upgrade the firmware on D-Link DIR-505 or 505L Mobile Companion. Step 1: Unplug the DIR-505/505L from the wall outlet, move the selector switch to Router/AP Mode. and plug it back in. Once the router finishes rebooting, the firmware will be upgraded.

How do I Reset my Dlink DIR 825 to factory settings?

This FAQ applies to hardware revision B

1. Step 1: With the unit on, use the end of a paperclip to press the reset button, which is located inside a small hole on the base of the unit.
2. Step 2: Using the paperclip, press and hold the reset button for more than ten seconds.
3. Step 3: The unit will reboot automatically.

How to flash a D-Link dir-505 with OpenWrt?

The easiest method to flash a DIR-505 with an OpenWrt factory image is via the D-Link Router Recovery Mode as described in http://forums.dlink.com/index.php?topic=44909.msg162511#msg162511 The essential how to for the D-Link Router Recovery Mode :

What does the fourth position on the dir-505l do?

The fourth position is used by the DIR-505L model to shutdown the software and operate as a USB charger – on the DIR-505 the case keeps the switch from going into the fourth position.

Are there different versions of the Dlink 505?

Apparently so far there are four versions of the dlink 505: DIR-505 A1, DIR-505L A1, DIR-505 A2, DIR-505L A2. They differ a bit on the “outer” hardware (switches, power supply stability, plugs), but the main router hardware is the same for all versions .