Why is my Sprint airave blinking red?

Why is my Sprint airave blinking red?

Use the external GPS antenna cable if your AIRAVE’s internal antenna is not receiving a sufficient signal (indicated by a blinking red GPS LED). Remove the GPS antenna module from the back of the AIRAVE. Connect the external GPS antenna cable to the antenna module and the AIRAVE.

How do I troubleshoot my airave?

Verify that the Airave is plugged in and receiving power. Verify that the GPS antenna base is located on a flat surface near a closed window. Make sure the Ethernet cord is plugged into the Airave and your internet modem/router. The reset button is located on the back, to the left side of the Ethernet port.

How can I use Airave on my Sprint phone?

All Sprint customers with a Sprint mobile device can use the AIRAVE and benefit from the enhanced coverage. Review the Setup Guide or Tutorial to ensure that Sprint Airave is properly installed. Verify that the Airave is plugged in and receiving power. Verify that the GPS antenna base is located on a flat surface near a closed window.

Why does my Sprint Airave not work with satellite?

The AIRAVE does not work with satellite broadband service because of too much jitter and delay, and the inability of some satellite broadband services to support IPSec. What happens if I have a power or Internet service provider outage? Your AIRAVE will not work during a power outage or ISP outage.

Can a Sprint Airave support static IP addressing?

Yes, the AIRAVE can support dynamic and static IP addressing. For instructions on how to select and configure static IP, please refer to the AIRAVE User Guide . Are there any safety concerns when using the AIRAVE?

Can a Sprint Airave work during a power outage?

Your AIRAVE will not work during a power outage or ISP outage. In the event of an outage, your wireless phone will automatically try to obtain service directly from the Sprint network if coverage is available. What is the recommended broadband bandwidth for the AIRAVE?