Are all Dana 60 axles the same?
There are three major variations of the Dana 60 axle used in the 1960s to 1980s. GMC, Chevy, and Jeep are all basically the same. Dodge and Ford are different. Dana 60 axles on the GMC, Chevy, and Jeep are all basically the same.
What Ford trucks have Dana 60 axles?
Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks. Each axle is built with a Bill of Material (BOM) Tag affixed to the differential cover by two cover bolts.
How do I identify a Ford Dana 60 front axle?
There are front and rear versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “60” cast in to the housing. Gross axle weight ratings are often lowered by the vehicle manufacturer for safety and tire reasons.
What years did Ford use Dana 60 front axle?
Ford Dana Super 60 Front Axle ID IDN-118 Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks.
How strong is a Dana Super 60?
The 84.74-inch-wide axle (an F-350 front axle is 69.8 inches wide) was designed for the ’05-and newer F-450 and F-550 Super Dutys, where it’s rated to support 7,000 pounds of gross axle weight (GAWR) and cope with more than 600 lb-ft of engine torque.
What trucks came with a Dana 60 front axle?
Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks. Each axle is built with a Bill of Material (BOM) Tag affixed to the differential…
What is a kingpin Dana 60?
If you’re unfamiliar with kingpins, they are the collection of components that allow a Dana 60’s knuckles to rotate and turn the vehicle.
What size is a Dana 60 axle?
The larger the housing, the more weight it can support. Dana 44 axle tube diameter ranges from 2.5″ to 3″, while the Dana 60 axle tube diameter is 3.125″. So, while the Dana 60 has a stronger housing than the Dana 44, it’s not by a massive amount, especially for the larger Dana 44s.
What gear ratio does Dana 60 have?
A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60.
What is Dana 60 rear end?
The Dana 60 is a Salisbury-type rear-end, meaning the differential carrier removes from the rear of the axle instead of the front. It can be identified by its 10-bolt rear cover, which appears to be lying on its side.
What is a Dana 60 axle?
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover . There are front and rear versions of the Dana 60. It can be readily identified by its straight axle tubes,…