How do I fix my Nissan P0507?

How do I fix my Nissan P0507?

What repairs can fix the P0507 code?

1. Replacing or cleaning the idle air valve.
2. Repairing the intake air leak.
3. Repairing the charging system.
4. Cleaning the throttle body.
5. Replacing the power steering pressure switch.

How do you reset the throttle body on a Nissan Altima?

Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.

What causes code P0507?

The P0507 code is triggered when the Engine Control Module (ECM) detects that the engine is idling higher than the specified idle rpm range. The standard engine idle is usually between 600-800rpm based on the model of the vehicle.

What is code P0420 Nissan?

Code P0420 stands for “Catalyst System Efficiency Below Threshold (Bank 1).” Put simply, this code indicates that your car’s computer has detected underperformance from the Bank 1 catalytic converter. The P0420 Code indicates that your car’s computer has detected underperformance from the Bank 1 catalytic converter.

What should a Nissan Altima idle at?

700 rpm in neutral or putting drive is normal or when idling at stops anything above 750 will turn on the check engine lite. Idle must set at dealer called idle volume learning if it gets out of specs and throttle body may have to be replaced.

How do I reset my electronic throttle control manually?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.

How do you reset the computer on a Nissan Altima?

Reset the computer and turn the service engine soon light off by repeating the first process completely, with one exception: When the pedal is lifted after pressing the pedal down for 10 seconds and the codes are flashing, depress the pedal again for an additional 10 seconds and the computer will reset.

How do I reset my electronic throttle control system?

How do I reset idle control?

Turn the ignition ON and leave on for several seconds then turn the ignition OFF to allow the ECM to reset the IAC valve. You should be good to go.

What does idle air control code p0507 mean?

P0507 is a fairly typical OBDII trouble code. It is typically triggered when the engine idle speed is 200 rpm or more over the predetermined limit set by the manufacturer. It is a generic code, which means that it has the same for the Nissan Altima as any other vehicle. P0507 Symptoms

What causes idle RPM on Nissan Altima p0507?

It would be a good idea to start by looking for a vacuum leak and move forward from there. A leaking vacuum system will often cause the Altima to idle higher. When the vacuum system leaks, it allows extra air to enter into the combustion chamber. This air allows for a slightly higher combustion, increases the RPM and throws the code.

How much does it cost to repair a Nissan p0507?

Please try again later. The cost of diagnosing the P0507 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What to do when ECM says p0507 trouble code?

At a certain point, the ECM can no longer compensate and sets a P0507 trouble code. You must remove the electronic throttle body to clean it. Apply throttle body cleaner to a clean rag and wipe the carbon off the throat and throttle plate.