How do I lower my truck with leaf springs?

How do I lower my truck with leaf springs?

Leaf springs are normally mounted on top of the rear axle; however, 3 to 4 inches lower can be achieved by flipping the mounts over so they rest on the bottom of the axle. Flip the mount to the lower side of the axle and then tighten the leaf springs back down into place.

Are all lowering blocks the same?

There is no difference, same blocks can be used for lifting or lowering. If you want to lower 3″, the blocks go between the rear leaf springs and axles…..

Can leaf springs be lowered?

Leaf springs with a bit less arch will lower the vehicle, but you’ll need to use stiffer springs to reduce the odds of inversion. This might not be a bad thing if you’re lowering the vehicle for better handling but it will certainly make the ride a bit rougher.

Can you cut lowering blocks?

Just make sure you cut at the correct angle depending on how your truck is set up. If you have an extended cab, you should have a slight (3-4*) angle on your blocks.

How do you adjust the height of a leaf spring?

Position one jack stand three to four inches from the end of the leaf spring, taking care not to lift the car too high. Use a wrench to loosen the bolts and remove the rear spring bolt from the trailing arm and spring. Carefully lower the jack to ease the pressure on the spring.

Do lowering blocks affect handling?

Lowering your car or truck so it’s closer to the ground is a popular way to customize your ride. Done right, it’s a great look that also boosts handling performance. Done wrong, it could compromise handling, drivability and traction, reduce tire tread life and even damage parts.

Do lowering blocks improve handling?

Can you use lowering blocks on a flip kit?

Typically, when it comes to lowering a leaf spring-equipped vehicle, it’s a pretty straightforward affair. A pair of lowering blocks and perhaps some longer U-bolts are usually all that’s needed. This requires a “flip kit” of some kind to get the springs under the axle before a set of lowering blocks can be installed.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top