What does 6TH Sense mean on Whirlpool washing machine?
In their washing machines it uses its sensors to monitor the load size and adjust the water level, water temperature and wash cycle time while in their tumble dryers the 6th Sense Technology monitors the load size and humidity allowing it to stop the dryer once the load is dry.
How do I reset my Whirlpool 6TH Sense washing machine?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
What is the function of 6TH sense in Whirlpool AC?
The other intuitive attribute is 6th Sense Sleep Function which senses the drop in temperature during the wee hours and adjusts to keep a comfortable temperature inside the room for a good sleep.
How do I unlock my Whirlpool 6TH Sense washing machine?
Hold down the “Control Lock” button on your Whirlpool washer for three seconds at the end of the washing cycle. Listen, and when you hear the unlatching sound, the door should open.
How do I turn off Whirlpool Sixth Sense washing machine?
To switch on the washing machine: press the “ON/OFF“ button, the “Start/Pause” button light up . To switch off the washing machine during the wash cycle, press and hold the button for approximately 3 seconds .
How do I clean my Whirlpool washer without affresh?
Natural Cleaners Vinegar and baking soda are amazing natural cleansers and can be used safely in your washing machine. Add a quart of white vinegar and a cup of baking soda to the cleaning mode and run the washer without clothes.
What does sd mean on a whirlpool washing machine?
Sd is displayed when the machine/motor control, by analyzing drag on the basket, detects a suds-lock condition, and is steady on while the control then runs a mini-clean out cycle. If the clean out cycle is unable to corred the over-sudsing problem, the cycle ends and Sd flashes in the display. This may signify: • Excessive detergent usage.
When to use diagnostics test mode on a whirlpool washing machine?
• Diagnostics Test mode if a stuck key is detected. • Standby mode if there is a user interface mismatch. F then 40 flashes when the ATC Thermistor is detected to be open or shorted. F then 41 flashes when the motor rotor position sensor (RPS) thermistor is detected to be open or shorted.
Why does my Whirlpool washer flash LF?
LF flashes when the water level does not change for a period of time after the valves are turned on OR water has disengaged the basket but control does not detect a water level change. • Is water supply connected and turned on? • Are hose screens plugged? • Is water entering the tub? If so check pressure hose connection to machine/motor control.