How do I access my Sophos UTM console?

How do I access my Sophos UTM console?

Access the UTM shell

1. Run PuTTY.
2. Click Open.
3. If it is the first time to connect to the UTM shell, PuTTY will display the following prompt.
4. A login prompt will then be displayed.
5. To sign in as root, enter the command su and enter the password for root.

What is the default password for Sophos?

Troubleshoot. In Troubleshoot, select 1. Reset console password. The admin password is reset to the default password: admin .

How do I reset my Sophos UTM password?

Reset Sophos UTM WebAdmin Password

1. Ensure you are still logged in as root as per the last step above.
2. Type cc at the prompt.
3. Type RAW.
4. Type system_password_reset.
5. Browse to the WebAdmin Interface.
6. Enter your new password into each box and hit Apply.

How do I find my Sophos admin password?

On Sophos Firewall go to Administration > Device Access > Default admin password settings. Enter your current password, then enter and confirm your new password. Click Apply.

How do I log into SSH Sophos?

The Source Network / Host is the IP address or network you will use to access the Sophos Firewall via SSH. The Destination Host is your WAN port….Turning on the SSH connection

1. Sign in to the Web admin.
2. Go to Administration > Device Access.
3. Tick the SSH box for the zones you want to allow access to.
4. Click Apply.

How do I setup a serial console using PuTTY?

To use PuTTY for your serial COM connections, follow these steps:

1. Figure out the COM port you’ll be using.
2. Run PuTTY.
3. Switch the Connection Type to Serial.
4. Edit the Serial Line to match the COM port you want to use.
5. Edit the Speed to match the BAUD Rate you want to use.

How do I reset my Sophos UTM?

Factory reset via Sophos UTM

1. Log in to the UTM WebAdmin.
2. Go to Management > System Settings > Reset Configurations or Passwords and then click Run factory reset now.

How can the admin password be reset to the default Sophos?

In the Options Menu, select 2 Troubleshoot and click Enter. In the Troubleshoot Menu, select 1 Reset console password and click Enter. Note: This will reset the password to the default value of admin . Change the password to a complex one.

How do I reset my Sophos UTM to factory settings?

Factory reset via Sophos UTM

1. Sign in to the UTM WebAdmin.
2. Go to Management > System Settings > Reset Configurations or Passwords and then click Run factory reset now.

How do I change my UTM password?

You can use the UTORid management page to reset your password, verify or activate your UTORid, setup or removing email forwarding. If you are unable to reset your password using the UTORid management page, you can book a remote password reset with the UTM Service Desk here.

How do I access Sophos XG CLI?

Connect to the XG from the CLI

1. Go to Administration > Device access to enable HTTPS on the required zone.
2. Disable the appliance access from the CLI using the following command:
3. For further analysis, you can do a Packet capture when you’re trying to access the GUI to find out more about the root cause.

How do I connect Sophos console cable?

Procedure

1. Connect the Micro USB, USB to RJ45, or the RJ45 to DB9 cable to the respective port on the Sophos Firewall and the other end to the PC’s respective USB or serial port.
2. Verify the COM port that is assigned to the serial connection.