What is the function of pressure switch in washing machine?
A pressure switch, or water level control, allows your washing machine to detect when it’s sufficiently filled. It can then close the valve from which your home or building’s water pressure pumps water into the machine.
Where is the pressure switch located on a Whirlpool Duet washer?
Locate the pressure switch inside the washer cabinet. From the rear of the washer, the switch will be on the rear left corner of the cabinet. The pressure switch is round with a wiring harness connecting to the back of the switch. The wiring harness has six wires attaching to the white harness block.
What causes pressure switch failure?
A pressure switch that fails to turn on could be caused by a number of problems, including: Failure of the draft inducer motor. Restricted intake air vent. Restricted combustion air vent.
Where is the water level sensor on Whirlpool washer?
Look for the water level switch on the right side of the cabinet toward the back of the washer. The round water level switch attaches to the side of the cabinet. A rubber tube connects the water level switch to the washtub.
How does a whirlpool duet water pressure switch work?
A Whirlpool Duet washer uses a water pressure switch to determine how much water to let into the tub. The switch also detects issues with oversudsing or overfilling.
Why is my Whirlpool duet washer not working?
My Whirlpool Duet washer displayed SUD and F35 errors. Turns out this is a common problem. Most people believe this to be the fault of the Analog Pressure Sensor (APS) and most people replace it. I did so and it worked — but now, three years later, the problem repeated.
Where is the pressure switch on a whirlpool washer?
Locate the pressure switch inside the washer cabinet. From the rear of the washer, the switch will be on the rear left corner of the cabinet. The pressure switch is round with a wiring harness connecting to the back of the switch.
How do you remove the top panel of a duet washer?
Go behind the Duet and remove the three screws securing the top panel to the rear panel with a Phillips-head screwdriver. Lift the rear of the top panel up and slide the top panel off the washer.