How do I reset my Ecolink tilt sensor?

How do I reset my Ecolink tilt sensor?

To reset the sensor to factory default, place the controller in exclusion mode and then insert the battery into the sensor to initiate power up. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

How do I reset my Z-wave motion sensor?

You can reset your ZSE18 Motion Sensor to factory settings by pressing and holding the Z-Wave button for AT LEAST 20 seconds. Once you see the LED indicator flash, stay solid, and then turn off, reset was successful!

How does Ecolink garage door tilt sensor work?

Garage-Tilt Sensor This Ecolink Garage Door Tilt Sensor is a Z-Wave Plus enabled device designed to smoothly integrate into a Z-Wave Plus home automation network. It will detect the opening of a garage door and will alert your system of any intrusion immediately. It can also be connected to an external trigger.

How does a garage tilt sensor work?

Typically, the components include a cylindrical cavity and a conductor inside to pass along electricity. When an item lines up straight, the conductor sits in the cavity and allows electricity to pass throughout the sensor. When a tilt occurs, the conductor moves out of the cavity, cutting off the electrical signal.

How do I reset my SmartThings hub?

How to Factory Reset a SmartThings Hub v3

1. Step 1: Unplug the Hub.
2. Step 2: While Holding Down the Reset Button, Plug in the Power Cable.
3. Step 3: Keep Holding Down the Reset Button Until the Light Flashes Yellow.
4. Step 4: Release the Button After 30 Seconds.
5. Step 5: Wait 4-5 Minutes for the Light to Flash Red and Green.

How do you do Z-wave exclusion?

1. Step 1: Install the SmartThings Classic App and Open It.
2. Step 2: Open the SmartThings Classic App Menu.
3. Step 3: Open the Smart Hub’s Settings.
4. Step 4: Open the Z-Wave Utilities.
5. Step 5: Open the General Device Exclusion Utility.
6. Step 6: Enable Z-Wave Exclusion Mode for SmartThings Hub.