How thick will a hypertherm 85 cut?
Refer to the To… The Powermax85® 85-amp plasma power supply will stop manufacturing in December 2021, and will no longer be available for sale from Hypertherm….Cut capacity.
| Capacity | Thickness | Cut speed |
|---|---|---|
| Cutting | ||
| Recommended | 25 mm (1″) | 500 mm/min (20 ipm) |
| 32 mm (1-1/4″) | 250 mm/min (10 ipm) |
How thick will a hypertherm 65 cut?
Handheld or mechanized plasma system for cutting and gouging metal
| Operating data | ||
|---|---|---|
| Capacity | Thickness | Cut speed |
| Recommended | 3/4″ (19 mm) | 20 ipm (500 mm/min) |
| 1″(25 mm) | 10 ipm (250 mm/min) | |
| Severance | 1-1/4″ (32 mm) | 5 ipm (125 mm/min.) |
How thick can a hypertherm 45 cut?
The Powermax45® XP plasma cutter delivers increased cut capacity – up to 16 mm (5/8″) metal – as well as faster cut speeds, and automatic gas adjustment for quick, simple setup and operation.
What is unshielded plasma cutting?
Dual flow plasma (unshielded) This process utilizes two gases; one for the plasma and one as a shield gas. In smaller systems (under 125 amps), compressed air is often used as both the plasma and shield gases. Dual gas unshielded systems have an exposed nozzle and should not be used for drag cutting.
How much air is needed for a plasma cutter?
All plasma manufacturers include minimum air flow and pressure requirements for an air compressor in the owner’s manual. These requirements differ between systems, but as an example, an air compressor for a plasma cutter like the Hypertherm Powermax45® requires 6 cubic feet per minute (cfm) at 90 psi.
How thick will a 50 amp plasma cutter cut?
Excellent Air Plasma Cutter: The Cut-50 Plasma Cutter can easily cut up to 0.55”(14 mm) metal under maximum output with ultimate portability weighing only 21.56 lbs.
How many CFM does a plasma cutter need?
What is a CPC port on a plasma cutter?
A CPC port allows the plasma controller to communicate with the plasma cutter. Typically, it’s used in conjunction with a voltage divider. On the Hypertherm, the CPC port is a circular connection on the front control panel. They provide voltage feedback from the arc back to the controller.
What is a good plasma cutter to buy?
The 8 Best Plasma Cutters:
- Hypertherm Powermax30 Plasma Cutter – Best Overall.
- Hobart Airforce 40i 240V Plasma Cutter.
- Lotos LTP5000D Plasma Cutter – Best Value.
- Miller Spectrum 625 X-treme Plasma Cutter.
- Forney Easy Weld 251 Plasma Cutter.
- PRIMEWELD CUT50 Portable Plasma Cutter.
- SUNGOLDPOWER 50A Plasma Cutter.