What is a fridge closing cam?
The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack or wear down over time. If your door will not open and close properly you may need to replace the door closing cam.
Why won’t my refrigerator door stay closed?
Check inside the refrigerator to ensure there aren’t any food containers, open crisper drawers or misaligned shelves that could keep the door from closing properly. If the door still fails to shut tightly, check the door gaskets. Clean the refrigerator door gaskets with warm, soapy water and a soft cloth.
Why does my refrigerator door clicks when opened?
If the door begins to make a popping noise when you open and close it, chances are the plastic ring, also known as a bearing or closing cam, has a damaged notch or has cracked, says Appliance Parts Pros. Replacing the damaged cam will fix the Frigidaire refrigerator door and stop the popping noise.
Can refrigerator doors be replaced?
Modern refrigerators come with a lot of features and sometimes, a repair job or a situation where the refrigerator needs to be moved into a cramped space would require you to remove and replace the refrigerator doors. Replacing the refrigerator door is sometimes required during repair work.
What is the rubber around the refrigerator door called?
The seal around your refrigerator or freezer door — also called a gasket — does exactly what the name implies. It seals in the cold air so foods stay fresh.
How do you magnetize a refrigerator door seal?
To re-magnetize your fridge door seal, run a magnet 50 times along each side of each gasket, always going in the same direction. That will re – magnetize the strips and restore the seal of the door. Doing this every few years will keep a tight seal on your fridge door.
How can I make my refrigerator seal better?
Using a cotton swab, push some petroleum jelly into the groove underneath the loose rubber. This will make it easier to push the rubber back into place and will help seal any leaks. Then, just push the seal back into the channel.