Was the Chevy 409 a good engine?
Chevrolet’s 348/409 engines were good performers and they were dependable engines. The zenith of W engine development came in 1963 in an almost mythical full-size one-year-only Chevrolet built strictly for drag racing, the Z-11 Impala.
How much horsepower did a Chevy 409 have?
The top-trim versions of the street-car 409 churned out an astonishing 425 horsepower, while the Bill “Grumpy” Jenkins-tuned NHRA cars could run the quarter mile in under 13 seconds.Raj. 10, 1442 AH
What was the first car Chevy put the 409 engine in?
Chevrolet brought muscle car power to the people in the early 1960s, especially with the 1961 Chevrolet Impala SS 409. The mid-1961 introduction of the Chevrolet Impala Super Sport option package showcased another new arrival, the 409-cid V-8. A bargain at just $53.80, the SS “kit” was offered on any Impala.Dhuʻl-H. 15, 1427 AH
What years did Chevy use the 409 engine?
409. A 409 cu in (6.7 L) version was Chevrolet’s top regular production engine from 1961 to 1965, with a choice of single or 2X4-barrel Rochester carburetors.
How do you tell a 409 from a 348?
There are a few visual differences that distinguish a 348 from a 409. The most obvious is the dipstick location. The 348 has it on the left, or driver side; the 409 has it on the right, or passenger side. However, since the pans are interchangeable, it’s a simple matter to make one look like the other.Ram. 13, 1433 AH
What is a 327 engine?
The Chevrolet 327-cubic-inch V8 originated with the small-block family of engines that first appeared in 1955 with a 265 cubic inch powerplant. During its eight years of production, the potent 327 engine became known among small-block aficionados as a “mighty mouse” of a motor that was extremely compact and efficient.Muh. 29, 1435 AH
What is the difference between a 348 and 409?
How much torque does a 409 have?
Initially rated at 360 hp at 5,800 rpm and 409 lb-ft of torque at 3,600 rpm, the ’61 409 was equipped with a single Carter AFB four-barrel carburetor.Jum. I 24, 1438 AH
Did they make 1961 Impala SS?
Chevrolet debuted the full-size Super Sport Impala in 1961. Only 453 cars were optioned with the SS package that included SS logos on the side moldings and the trunk lid, a ‘Corvette-style’ passenger grab-bar and suspension/brake upgrades.
What was the fastest car in 1961?
The Aston Martin DB4 was produced from 1958 until 1963, with its 3670 cc DOHC six cyinder engine producing 240 hp and propelling it to a top speed, as tested by Autocar magazine in 1961, of 141 mph(227 km/h).Saf. 27, 1438 AH
How do I identify a Chevy 409 engine?
One of the quickest ways to spot a 348 or 409 block is by its front. W engines have the two water pump inlets to the block spread out across the front. The holes are located very close to the outside of the block and their inlets (with one side flattened) are closer in shape to a diamond than a circle or oval.
What is the difference between a 396 and 402?
Although it displaced 6-cubic-inches more than the 396 and had a bore that was 0.03 inches wider than the 396, Chevrolet marketed the 402 as a 396 on its smaller cars like the Nova, while labeling it as a 402 in its full-size automobiles.
When did the Chevy 409 V8 come out?
Chevrolet 409 V8 Engine. The Chevy 409 V8 was introduced in December of 1960 as the engine of choice for the all new 1961 Impala Super Sport. It was put into production by GM because of the performance ground that had been lost due to the new highly successful Ford 390 that had been gaining respect at the local race tracks the same year.
What was the wheelbase of the Chevy 409 in 1960?
Cars were shortened from 210.8 to 209.3 for this year. Wheelbase remained at 119 inches. All powerplants of 1960 were kept again for this year with a new addition, the 360hp 409 which arrived later in the model year. (production began in January of ’61) This accounts for it’s low production number of only 142!
What kind of engine did Chevrolet have in 1961?
This year, a 2 door sedan was available on the Impala model however it would be dropped after this year making it the only year for this style. Standard engines for 1961 were the 135hp 235 six cylinder or the 170hp 283 V-8.
How many Chevy Impala SS’s were made in 1961?
©2007 Publications International, Ltd. The engine in the Chevy Impala was all about power. Chevy built 491,000 Impalas for ’61. Only 453 had the SS package and of those, just 142 got the 409. But word spread quickly.