What causes a Maytag washing machine not to spin?

What causes a Maytag washing machine not to spin?

One of the most common reasons for a Maytag top load washer not spinning is an incorrect wash cycle or spin setting. GENTLE, HANDWASH, or DELICATE settings utilize slower spin speeds for more fragile fabrics. Some model washers also allow you to vary the spin speed, making it slower or more rapid, for different loads.

Why is my washer running but not spinning?

An unbalanced load of laundry is one of the most common causes of an inadequate spin cycle. Sometimes clothing can settle on one side of the drum, throwing off the motion of the washing machine. If you suspect a distribution problem, try rearranging your clumped-up wet laundry and running the spin cycle again.

How do I reset my Maytag washer?

If an error message causes your Maytag washer to not run properly, reset the washer to clear the error message….How to Reset a Maytag Washer

1. Press the “Power/Cancel” button.
2. Push the appropriate button to choose a new cycle.
3. Press “Start/Pause.” You have now reset your Maytag washer.

How do you reset the sensor on a Maytag washer?

How to Reset the Maytag Centennial Washer?

1. Select “Power Off” and then “Cancel”.
2. To change the cycle, press the corresponding button.
3. Then press “Start/Pause.” The Maytag washer is now reset.

Is there a reset button on Maytag washing machines?

Press “Start/Pause.” You have now reset your Maytag washer.

What is the most likely cause of a washing machine will not agitate or spin?

The washer transmission might be worn out or defective. Transmissions have gears in them that can fail causing the washer to not spin or agitate. If the motor is turning the transmission, but the washer won’t spin or agitate, consider replacing the transmission.

How do you reset the lid lock on a Maytag washer?

If your lid lock light is flashing, you can unplug your washer for 10 minutes and plug it back in to reset the washer and the flashing light. You can also press and hold the ‘End of Cycle’ button for 20 seconds to reset the washer and flashing lid lock light.

Why is my Maytag washing machine not spinning?

One common cause why a Maytag top load washer won’t spin is due to an uneven load or jammed clothing . Larger items or loads tend to settle on one side of the washer drum during a cycle. Try to redistribute the load or remove a few articles of clothing and run the spin cycle on your washer again.

What is wrong with my Maytag washer?

Check for excessive soap suds accumulating in the washing machine. Maytag recommends you use only high-efficiency detergent in Maytag washers. Other detergents can cause excessive soap suds, which could cause the washing machine to operate at a slower spin speed than selected, resulting in sopping wet clothes.

What are some common problems with the Maytag Bravos washer?

Bearing: Tub bearing is located in the middle of the outer tub.

Drive Pulley: A crack or worn-out drive pulley works behind the loud sound of a washer.

Drive Belt: With the time growing a drive belt can be burnt out or cracked that makes a loud sound while the machine runs.

Why is my Whirlpool washing machine not spinning?

Causes and Repair for a Whirlpool Washing Machine That Won’t Spin or Rinse Agitation Without Rinsing. A washer that will spin but not rinse will leave your clothes covered in detergent or suds. Agitation Without Spinning. Filling Without Spinning or Rinsing. No Agitation, Spinning or Rinsing.