How do you put a western plow in float mode?

How do you put a western plow in float mode?

Double-tap on the down button to put the blade into float mode. If your plow doesn’t have a float mode, simply press the down button until the bottom edge of the plow touches the ground. Drive forward at 10–15 miles per hour (16–24 km/h).

Why is my Western plow not working?

An easy fix and possible cause of the problem is that either the incorrect hydraulic fluid is being used, or the fluid level is too low. The hydraulic pump may also be clogged; the pump filter will have to be replaced, and he hydraulic system will have to be flushed and refilled before the plow will function properly.

Why is my plow not getting power?

Check for power problems. If the motor isn’t allowing you to engage the plow, the problem could be with the battery or its connection, the motor itself, a blown fuse or an issue with your controller. Clean your battery leads and posts with a wire brush and fill the water cells to your battery’s specifications.

What does a plow module do?

Western Snow Plow Isolation Modules are the brains of the Western plow electrical system. When you push a button on your hand held controller, that information is passed onto the Isolation module in order to help notify the plow of the movement as well as pass this information to the hydraulic system.

How do you plow a gravel road?

Techniques for Plowing Gravel Driveways and Roads

1. Go slow!
2. Adjust the blade height.
3. Tilt the front of the blade.
4. Wait for 2″ of snow.
5. Turn off the radio and listen while you plow.
6. Start at the center.
7. Take multiple passes for heavy accumulation.

How do you use Boss V plow?

If you have a Power-V Plow, use the V-position for the first pass. Then change to the Scoop or Angle-position to widen things out. You should push just enough snow with each pass to get the job done efficiently without overloading your equipment.

What are the parts for a Western plow controller?

Western SnowEx Part # 64312 – Hand Held Control Bracket Parts Bag is the kit needed in order to mount your handheld plow controller to the dash of your… Western Plow Part # 96437 – Harness 6 Pin White Connector for Straight Blade Hand Held Controller. This only works with the straight blade handheld controls.

How much does a snow plow controller cost?

Snow Plow Joystick Controller W/Cables 1314000 Suitable Western Fisher Snowplow 4.4 out of 5 stars3 $178.99$178.99 Get it Mon, Sep 13- Thu, Sep 16 FREE Shipping New Snow Plow Joystick Controller w/Cables 56018 for Compatible with Western Snowplow + Full Model List in Description $243.34$243.34 FREE Shipping

Can a wireless remote be used on a wired snow plow?

For those of you that would rather go Wireless and save money on parts for your Western Snow Plows, be sure to check out SnowplowsPlus EXCLUSIVE wireless remote controller that can be used on many different straight blade snow plows in place of your OEM wired controller.