How do I reset my Contour Next Link meter?

How do I reset my Contour Next Link meter?

You can turn a meter setting off or on from the meter using the following steps:

1. Turn off the meter and move away from your mobile device.
2. Turn your meter on.
3. Scroll to Settings.
4. Press ‘OK’ on each screen until you find the setting to change.
5. Use the up and down arrows on the outer ring to change the setting. Press ‘OK’

How do I change the battery in my Contour Next Link?

Remove the old batteries by pressing the top of the battery which will raise the bottom of the battery up. Place new batteries under the prongs and into the battery compartment with the “+” side up. Slide the battery cover back into place, lining up with the open slots, and close firmly.

How do I reset my diabetes meter?

Press and hold the M (Memory) button for 7 seconds to restore the glucometer’s factory settings. Restoring factory settings: Restores the date by default (01/01/2017). Remember to reconnect the glucometer before taking new offline measurements.

How do you calibrate a glucometer?

To calibrate, you must use a fingerstick blood sample to test your blood glucose (BG) on your meter and then enter that value into your pump. The pump will accept BG meter readings between 40 mg/dL to 400 mg/dL.

What kind of battery does Contour next use?

Watch battery: The Contour ONE meter uses a round watch battery.

What does e7 mean on a diabetic machine?

E-7 message “E-7” in the display means an electronic error occurred or, in rare cases, a used test strip was removed and reinserted. Turn the meter off and on or take the battery out for 20 seconds and reinsert it. Perform a blood glucose or control test. If the problem persists, please contact Accu-Chek Customer Care.

How do I set the time on my Contour Next meter?

Your CONTOUR NEXT ONE meter comes with Meal Markers turned Off. You can change the time format, time, date format, date, Sound setting, Meal Marker setting, and the Target Light (smartLIGHT) setting by going to the Home screen and selecting Settings . See page 37.

How do you change the time on a contour next meter?

How do I change the date and time on my Bayer Contour, Contour XT, Contour NEXT EZ or Contour NEXT ONE meter?

1. Step 1) Turn the meter on in Settings mode.
2. Step 2) Set the Time.
3. Step 3) Set the Month and Day Format.
4. The meter will now proceed through sound and basic/advanced mode setup.

How do you charge a Contour Next Link meter?

Your CONTOUR®NEXT USB meter has a rechargeable battery. You must charge your meter by plugging it into the USB port or wall charger. After one minute of charging, you can run one blood glucose test if needed. The meter is fully charged when the test strip port light stops flashing and turns off.

How do you change the time on a Contour Next Link meter?