Can you rebuild an injection pump?

Can you rebuild an injection pump?

Rebuilding an injection pump is more than just replacing seals. Worn hard parts need to be replaced, settings made and pump calibration set. Disassembly and reassembly of an injection pump requires special tools to prevent damage and properly set for optimum operation.

How do you disassemble an injector pump?

How to Remove a Diesel Injector Pump

1. Lift the front of the vehicle with the jack and put it onto jack stands. Locate the injector pump, which is typically on the driver’s side framerail.
2. Unplug the harness running to the injector pump. Disconnect the quick-disconnect clips leading to the injector pump with your hands.

How much does it cost to rebuild a injector pump?

Labor costs are estimated between $481 and $607 while parts are priced between $1,252 and $1,715. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed. This range is an average across all vehicles on the road.

How do I know if my injection pump is bad?

Symptoms of a Bad or Failing Diesel Injection Pump

1. Engine may run roughly, or not at all.
2. Hard starting.
3. Engine misfires.
4. Lack of power.
5. Excessive smoke from the exhaust.

How much does it cost to rebuild a diesel injection pump?

New pump would be about $2400, with $500 labour to remove and refit, and injectors are around the $400 mark too.

Can you rebuild your own injectors?

The fuel injector controls the flow of gasoline or diesel into the combustion chamber. If you have the proper equipment and plenty of patience, it is possible to clean and rebuild your own fuel injector. This will save you money over having the part repaired professionally.

What is the first step in removing a fuel injection pump?

Global Navigation

1. First, you’ll need to lift the vehicle so you can remove the tank.
2. Next, remove the clamps from the fill lines and then remove the fill lines as you prepare to drop the gas tank.
3. Next, you’ll need to disconnect the wire connectors and fuel lines that connect to the module.

Is a fuel pump and injector pump the same?

The fuel pump is one of the most vital components for making the car run. It uses pressure to literally pump fuel from the fuel tank to the injectors, so it’s not that uncommon for it to be also called an injector pump. There are two types of fuel pumps: mechanical (older) and electronic (newer).

How long does it take to replace injection pump?

The labor to replace the in tank fuel pump and the inline fuel filter that should be replaced with the fuel pump will take 4 to 5 hours labor.