How do I know if I have a 24x or 5xx Reluctor wheel?
One easy way to tell which reluctor wheel you have is to look at the crankshaft sensor. If it’s black you have a 24x wheel; if the sensor is gray then you have a 58x wheel.
What Reluctor wheel does a 2006 GTO have?
All GTO’s [2004 to 2006] have: a) A 24x crankshaft reluctor.
What does the Reluctor wheel do?
The reluctor wheel features a series of teeth that provide crankshaft position signals (via a sensor) to the ECM. The wheel interference-fits to the rear of the crank, immediately forward of the No. 5 main bearing. Typically the wheel features about a 0.007” interference fit.
What is a 58 tooth reluctor wheel?
engine gm. Around 2005 or 2006, GM started using a 58-tooth reluctor wheel, where before they used a 24-tooth wheel in the LSx based engines (LS1, LS2, LS3, etc.). This wheel is used as a way for the computer to detect where the crankshaft is at in its rotational cycle.
How do you remove a Reluctor wheel?
Proper position of the wheel is essential. To avoid bending or distorting the reluctor wheel, DO NOT use a puller when removing it. We recommend heating the wheel with a torch to about 200ºF. Like all metal, the wheel will expand and you should be able to slip it off easily.
What is a Reluctor?
Noun. reluctor (plural reluctors) (automotive) A toothed ring or wheel that rotates past a variable reluctance sensor.
What year did LS go to 58x?
These engines used a 24x crankshaft trigger wheel and a cam sensor mounted at the rear of the camshaft. Roughly in 2003, GM upgraded the LS into its Gen IV configuration with a number of changes. The upgrades included a 58x crank trigger wheel with the cam sensor moved to the timing chain cover.
Is a 6.0 A LS1 or LS2?
The main difference between the engines in the LS family is the displacement, intake, camshaft, and various small details. But, the most obvious difference between the two is the displacement. The LS1 has a displacement of 5.7L, whilst the LS2 has a displacement of 6.0L.
How do you install a Reluctor wheel?
Heat up the wheel with a torch, somewhere near 200-degrees (fahrenheit) and using heat resistant gloves, pull the reluctor wheel off of the crankshaft. The reluctor wheel with Goodson’s jig in place. Installation is just as simple. Check for any burrs on the wheel or mating surfaces.
How does a Reluctor ring work?
The reluctor ring is mounted on the crankshaft so that as the crankshaft rotates the magnetic sensor is triggered by notches in the reluctor ring. The magnetic sensor provides position information to the electronic control module, which governs ignition timing.
How many wires does a VR sensor have?
A Reluctor sensor is typically a 2 wire sensor and does not have any fancy electronics. A Reluctor is made up of a permanent magnet, a ferromagnetic pole piece and coil of wire.
Is a Reluctor magnetic?
ignition systems …a magnetic device, called a reluctor, that is operated by the distributor shaft to produce timed electric signals, which are amplified and used to control the current to the induction coil.