How do I fix Error 46 on Brother printer?

How do I fix Error 46 on Brother printer?

Part 1 – Put the printer into Maintenance mode: Keeping the button pressed down, plug the power cord back in and hold the button until you see a maintenance mode message (or ‘Error 46’ as Glenn pointed out in the comments) on the screen. Your printer screen should now read ‘Maintenance’.

How do I clear a Brother printer error?

To clear these messages, follow these steps:

1. Press the ON/OFF key to turn the Brother machine off.
2. Unplug the Brother machine from the electrical outlet.
3. Wait approximately ten seconds.
4. Plug the Brother machine back into the electrical outlet.
5. Press the ON/OFF key to turn the Brother machine on.

What do you do when your brother printer says ink absorber is full?

The error “Ink Absorber Pad Full” means that the internal ink absorber or flushing box will need to be replaced. The need to replace these items and the time period before replacement is dependent on the number of purges and flushes required to clean the ink system.

How do you reset the purge counter on a Brother MFC j200?

Purge Counter Reset Instructions

1. With the printer turned on and ready to print remove the power cable from the printer (or turn the printer off if you have a fixed power cable).
2. Hold down MENU/SET/START and re-insert the power cable/turn it back on.
3. Keep the button held down until the screen reads MAINTENANCE.

How do I get my printer out of error state?

Sometimes, simply restarting both your computer and printer can be the solution to the “printer in error state” issue. Power off your printer and computer completely, leaving them in this state for a few minutes, then turn them on again to see if the problem is gone.

Why does my Brother printer keep saying error?

Difficulty printing from your PC can occur for various reasons. The most common reason a networked Brother machine may stop printing, is because the connection between the computer and the Brother machine is lost. This can occur as a result of wrong settings or configuration of the printer driver.

How do you fix an ink absorber that is almost full?

Press and hold the “Power” button and reconnect the power cord. When the printer comes on, release the button. Wait five seconds and push the “Power” button again. This resets the printer’s internal memory and overrides the “Ink Absorber Full” error code.

What do you do when your ink absorber is full?

When the message “Ink absorber full.” is displayed, the printer stops printing and needs ink absorber replacement. Push the power button to turn OFF the printer, and then contact the service center for replacement. Request either Canon or the dealer you purchased the machine for a repair service.

How do I fix Error 48 on Brother printer?

Troubleshooting Print Head problem

1. Plug out the printer power cord.
2. Lift the scanner cover gently.
3. Look inside the printer. If there is any paper part jammed, remove it.
4. Do check for any scrap beneath the printer head.
5. Move the printer head to the center if it is hung in the right or left corner.

How do I clear the memory on my Brother printer?

Press the blue key labeled BLACK START or the green key labeled COLOR START on the Brother machine to send or copy the pages you have scanned so far. Press the STOP/EXIT key to cancel the job. a. If the ‘Out of Memory’ message continues to appear, you should clear some jobs from your Brother machine’s memory.