Where is the fuse for the dash lights on a 2008 Chrysler Sebring?

Where is the fuse for the dash lights on a 2008 Chrysler Sebring?

The 2008 chrysler sebring interior fuse box is under the driver’s side of the dash.

Why is my dash panel not working?

If the dashboard isn’t lighting up at all, your car might have blown a fuse. Removing the old fuse and replacing it should get the lights working again. While the new fuse may do the trick, it could also indicate a deeper electrical problem.

Where is the fuse box located on a 07 Chrysler Sebring?

Fuse box location A Totally Integrated Power Module is located in the engine compartment near the air cleaner assembly. This center contains cartridge fuses and mini fuses. A label that identifies each component may be printed on the inside of the cover.

Where is the horn fuse on a 2010 Chrysler Sebring?

The 2010 chrysler sebring horn fuse is located in the fuse box under the hood.

Where is the fuse for the dashboard lights?

Fixing Dashboard Lights: Finding a Blown Fuse The instrument panel fuse box is usually located inside the vehicle, and usually on the driver’s side. There should be a diagram inside the fuse box (or in the owner’s manual) that shows you what each fuse powers.

Where is the horn fuse for a 2008 Chrysler Sebring?

The 2008 chrysler sebring horn relay is located at the fuse panel under the hood.

Is the Chrysler Sebring dashboard the same as the Avenger?

The same PCB (printed circuit board) and schematics was used by Chrysler to build dashboards for couple of they cars, either if is Chrysler Sebring , Dodge Caliber or Dodge Avenger and other, the electronics inside the dashboard is the same. On the outside, gouges may look a bit different from model to model but inside , they are all the same.

What to do if your dash lights are not working?

If that does not work you need to remove the instrument cluster and check for power on the cluster connector. with the Headlight turned on, you should have power at pin #12. If no power, check the BCM directly.

How are the lights on the dashboard controlled?

The lights on the dashboard are directly controlled by the body control module (BCM). This may reset the BCM. If that does not work you need to remove the instrument cluster and check for power on the cluster connector. with the Headlight turned on, you should have power at pin #12.