How do I reset my Brother printer manually?

How do I reset my Brother printer manually?

Reset Your Brother Machine

1. Press Menu.
2. Press or. to display the [Initial Setup] option, and then press OK.
3. Press or.
4. Press or.
5. Press the option in the table to reset the machine or to exit the process.
6. Press the option in the table to reboot the machine or to exit the process.

How do I reset my DCP Brother printer?

Press Menu from the printer control panel. Using the Up or Down Arrow keys, select Initial Setup and then press OK. Using the Up or Down Arrow keys, select Reset and then press OK.

How do I reset my brother TN 630 TN 660 toner?

1. Open front door.
2. Turn off printer.
3. While holding down the GO button, turn printer back on.
4. When all four LEDs light up release GO button. All LEDs will turn off.
5. Press the GO button 2 times.
6. Press the GO button 5 times.
7. Paper light will be blinking.
8. At this point the toner end-of-life condition has been reset.

How do I bypass the low toner on a Brother printer?

A simple trick on many Brother printers showing a “low toner” warning is to simply pop the cartridge out of the printer, wait a moment, and push it back in. This resets the printer memory and tells the machine to “look again” at toner levels. This can allow you to get more out of your Brother toner cartridge.

How do I clear my Brother printer?

To determine if this is the case, right click on the available driver and left click on Printer Properties. If you are given the option to choose the Brother Printer Driver, then it is installed. Cancel the print jobs. To cancel all documents click Printer => Cancel All Documents (or Purge Print Documents).

How do I get my Brother printer out of error mode?

You can do it in a few simple steps by unplugging the power cord from the wall outlet and then again switching it on. You can update or re-install the printer driver. According to many Brother Printer users, the Error State is often caused by the corrupting of the printer drivers. The technicians also suggest the same.

How do you clear a printer’s memory Brother?

Press the blue key labeled BLACK START or the green key labeled COLOR START on the Brother machine to send or copy the pages you have scanned so far. Press the STOP/EXIT key to cancel the job. a. If the ‘Out of Memory’ message continues to appear, you should clear some jobs from your Brother machine’s memory.

How do I reset my brother TN 630 drum?

(1) Make sure that the front cover is open. (2) Press and hold OK for about two seconds to display Drum Unit, and then press OK. (3) Press the up arrow to display Reset and reset the drum counter. (4) Close the front cover.

How do I reset my brother DR 630 drum?

How to Reset DR630 Drum for all other Brother HL Printers

1. Open the front compartment door.
2. Press and hold the “OK” button for about 2 seconds.
3. When “Drum Unit” appears on the display, press “OK”
4. Press the arrow button until the display reads “Reset”
5. Reset the counter to zero.
6. Close the front compartment door.