How do I reset my Allison Transmission Control Module?

How do I reset my Allison Transmission Control Module?

Steps to Resetting Transmission Control Module

  1. Step 1: Turning Key Position.
  2. Step 2: Press gas pedal.
  3. Step 3: Keep Waiting.
  4. Step 4: Turning the Key Off.
  5. Step 5: Releasing Gas Pedal.
  6. Step 6: Wait Again.
  7. Step 7: Ready.
  8. Identification.

Where is the TCM on a 2005 Duramax?

The tcm is under a black plastic cover on the fan shroud. You’ll have to unbolt the cover and then unclip the tcm.

What does the TCM module do?

The TCM is an electronic mechanism that collects data from the transmission, interprets signals sent from other parts of the vehicle (i.e. throttle position sensor, turbine speed sensor, fluid temperature sensor, etc.), and helps to regulate the gears shifting.

Where is the TCM on a Allison Transmission?

Transmission controller is located on the drivers side of the radiator shroud of all Duramax powered GM’s. This product may be added to any SPADE order, or purchased by anyone using an EFILive Flashscan V2 to tune their truck. Alternatively, a physical TCM module may be sent with payment of additional core charge.

What is the AL5 Transmission Control Module in a Duramax?

The AL5 Transmission Control Module is found in the 2001-2005 2500HD/3500 Duramax with the Allison Transmission. We offer a Pre-programmed TCM which comes with either factory calibrations or our enhanced calibrations. Revised shift strategies for better shift RPM & quality. Improved torque converter lock-up.

Where is the Transmission Control Module located on a Chevy?

The TCU process, along with the ECU, will certainly work cooperatively. They will try to learn your driving technique. They will certainly check your driving pattern and take care of that as well. The transmission control module is usually located at the rear of the transmission case, precisely under the cover.

What kind of TCM does a GMC 2500HD have?

Plug & play AL5 TCM for the 2001-2005 6.6L Chevrolet/GMC 2500HD/3500. The AL5 Transmission Control Module is found in the 2001-2005 2500HD/3500 Duramax with the Allison Transmission. We offer a Pre-programmed TCM which comes with either factory calibrations or our enhanced calibrations.

Can a faulty transmission control module be programmed?

Yes, if you use an ODB-II scanner, it will throw some error codes specific to a faulty Transmission Control Module (TCM), including codes such as P0613, p0700 transmission control system, P0706, ETC. Does a TCM need to be programmed?

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top