How do I set the time on my polar FT7 watch?

How do I set the time on my polar FT7 watch?

Select Settings > Watch, time and date .

1. Alarm: Set alarm Off or On.
2. Time: Select Time 1 and set the time format, hours and minutes.
3. Time zone: Select time zone 1 or 2.
4. Date: Set the date.
5. Watch face: Select Time only, Time and logo or Birthday logo (Selectable only on birthday).

How do I reset my Polar heart rate monitor?

To reset your heart rate sensor:

1. Remove the battery.
2. Press the metal snaps that attach to the strap with your fingers for at least 10 seconds.
3. Wait 30 seconds and then put the battery back in.

How do I pair my Polar heart rate monitor?

To pair a heart rate sensor with Polar Beat:

1. Wear the sensor.
2. Open Polar Beat app on your Android or iOS device.
3. Go to the settings section of the app and find HR sensor. When your sensor is found, tap PAIR.

How do I reset my polar A360 watch?

You can also reset your A360 from the bracelet itself: Press and hold the button to enter the row of icons menu. Ignore the sync/pair message and keep pressing the button….Reset A360

1. Connect your A360 to the computer with the supplied USB cable.
2. Open settings in FlowSync.
3. Press the Factory Reset button.

How do you pair Polar Heart Rate Sensor?

How to reset the heart rate monitor on polar FT7?

If there are no reactions to any buttons or the FT7 displays unusual readings, reset the heart rate monitor by pressing four buttons ( UP, DOWN, BACK and LIGHT ) simultaneously for four seconds. The display will go blank for a moment. Press OK and Please enter basic settings will shortly be displayed.

How do I Reset my Polar watch to factory settings?

Go to flow.polar.com/start and download and then install the Polar FlowSync data transfer software onto your computer. Connect your watch to the computer’s USB port. Open settings in FlowSync. Press the Factory Reset button. Now you need to set up your watch again, either via mobile or computer.

How to activate night mode on polar FT7?

Night Mode during training: Press LIGHT once during recording and the backlight will be activated by pressing any button. Night mode is switched off when the FT7 goes back to Time mode. To activate your Polar FT7 heart rate monitor, press and hold any button for one second.

What should I use to clean my polar FT7 connector?

Dry the connector with a soft towel. Never use alcohol or any abrasive material (steel wool or cleaning chemicals). Clean the strap gently with mild soap and water solution when needed. Do not use moisturizing soaps as they can leave residue on the strap.