What are the parts of a pool cue?
Pool Cue Anatomy 101
- TIP. The tip is the part of your pool cue that you use to strike the cue ball.
- FERRULE. Right underneath the tip is the ferrule.
- SHAFT. The shaft is the top and longest half of a two-piece cue.
- JOINT COLLAR.
- JOINT PIN.
- BUTT COLLAR.
- FOREARM.
- WRAP.
What is the best material for a pool cue?
Customarily, a pool cue of exceptional quality is made from a straight-grained hard rock maple wood, especially the shaft. Today, many different types of woods are being utilized amongst cue makers, and continue to increase in popularity.
What is a cue ferrule?
The ferrule is that little white piece just below your tip at the top of your shaft. At its most basic level, the ferrule is your pool cue’s shock absorber. Like a car’s shock absorber, the ferrule provides an additional level of control over your pool cue.
What is the end of a pool stick called?
The heavy, lower piece of the cue is the cue butt, and the smaller, narrower end is the shaft. The two cue pieces are attached at the joint; normally a screw rising from butt end’s joint (male) is threaded into a receptacle on the shaft (female), or vice versa.
What is the tip of the cue stick made of?
leather
Pool cue tips are glued onto the white ferrule of the cue (billiard stick) and are in direct contact with the ball. The tips are chalked during play to avoid the cue slipping and ensure maximum impact. These cue tips are mostly made of leather. Hard leather is pressed and the fibres are compressed accordingly.
What wood is used for pool cues?
rock maple wood
Good quality pool cues are customarily made from straight-grained hard rock maple wood, especially the shaft. Snooker cues, by contrast, are almost always made of ash wood, although one might come across one with a maple shaft. Maple is stiffer than ash, and cheaper.
What weight pool cue do pros use?
19 to 19.5 ounces
A: The pros use cues which weigh 19 to 19.5 ounces. Available pool sticks range from a low of about 15 to as much as 27 ounces, an extra half-pound over the pro cue.
How do I keep my pool cue from warping?
Warping Prevention
- Don’t lean your cue up against any surface, such as a wall or the pool table.
- Don’t leave your cue next to any heat source, such as a radiator or fireplace.
- Don’t store it in extreme hot or cold—such as a basement or attic or hot car.
What are cue ferrules made of?
The ferrule is the small band of metal towards the top of the cue, just underneath the tip. Traditionally they have been made of brass, but more recently other materials have been used.
How do you change a ferrule on a pool cue?
Replace the ferrule if there is a split down the side and a tenon running right through the center of it. Use a lathe or a pair of pliers to remove the ferrule. Squeeze the split on the opposite side and move it around to remove it. Just be careful not to damage the wooden tenon in the middle of the cue stick.
What materials are used to make a pool cue?
Most cues are made of wood, but occasionally the wood is covered or bonded with other materials including graphite, carbon fiber or fiberglass. An obsolete term for a cue, used from the 16th to early 19th centuries, is billiard stick .
What are the parts of a cue stick?
Tip – You hit the ball with the tip. It’s usually made of leather,though the hardness of the leather (hard or soft) varies by cue.
What is a pool stick?
• POOL STICK (noun) The noun POOL STICK has 1 sense: 1. sports implement consisting of a tapering rod used to strike a cue ball in pool or billiards. Familiarity information: POOL STICK used as a noun is very rare. Dictionary entry details.