Why is my chainsaw cutting sideways?

Why is my chainsaw cutting sideways?

Uneven cutting teeth is often the cause. If the chain is cutting to the left that means the right teeth on the chain are longer, and vise versa. To correct, sharpen only the side with the longer teeth. If the bar has worn unevenly it will also cause the chain to not cut straight.

Can a chainsaw cut horizontally?

Make a horizontal cut as close to the ground as possible. Go slow and keep the chainsaw steady. If you find that the chainsaw chain is getting pinched, use a wedge to keep a separation between the top and bottom layers of wood.

How do I know if my chainsaw bar needs replacing?

Common signs that indicate it is time to replace the chainsaw bar are:

1. Damaged or Bent bar.
2. Chain wiggles side to side on the bar.
3. The edges of blades are tilted at an angle.
4. A jammed or damaged bar nose sprocket.

How long should chainsaw bar last?

On average, a chainsaw bar could last ten years unless it becomes damaged or bent. However, how long a chainsaw bar lasts depends on hours of use. If you only use your saw occasionally and maintain it properly, a bar could last as long or longer than the chainsaw.

What is the bar plate on chainsaw?

The bar plate is made of metal and sits against the saw’s housing (where the bar mounts). It can really be thought of as a guard. Its primary function is to strengthen the area where the bar mounts. The saw’s plastic housing would quickly wear from the movement (and heat) of the bar if the bar plate weren’t there.

Can you cut sideways with a chainsaw?

Chains saws (well, most two stroke engines) are designed to be used at any angle, even upside down. Cutting sideways shouldn’t bother it at all.

How often should you change the bar on a chainsaw?

If you are looking for a general idea for how often you should replace a chainsaw bar, a rule of thumb is to replace the bar of your chainsaw once after you have gone through three chains on the same bar.

What makes a chain saw cut to one side?

When the chain saw starts cutting to one side or the other, it may be due to a problem with the teeth. Over time and with use, the chain saw teeth wear down and become dull.

What should I do if my Stihl chain saw starts to spin?

After cleaning the air filter and spark arrestor, you should fill the tank, start the saw and let it warm up for a few minutes before adjusting the carburetor. Set the idle screw to the point just before the chain starts spinning and adjust the low-speed midway between the the two points at which the engine starts to die.

Why does my Stihl chain saw bog down when I’m cutting?

The reason for that may be you’re using the saw at altitude or the carburetor adjustment has simply slipped. The saw also won’t operate well at speed if the air filter or spark arrestor or carburetor are dirty.

What should I do if my Stihl saw keeps stalling?

Cleaning the filters and adjusting the carburetor are part of a tune-up procedure that you should conduct regularly to keep your saw running well. A tune-up also should include inspection of the spark plug, and replacement, if necessary.