Why do torque converters burn belts?

Why do torque converters burn belts?

Overloading the Torque Converter If his range is exceeded, it can cause excessive wear on the belt and pulley system as well. If you constantly drive uphill at slow speed, especially with a heavy load, this will also prematurely burn out the belt on your torque converter because it is “slipping” the entire time.

How do you adjust a comet torque converter?

Adjusting your Torque Converter in 4 Easy Steps

1. Step 1 – Remove the Nut, Snap Ring, Cam and Spring. In order to adjust your torque converter, you must get access to the spring.
2. Step 2 – Adjust the Spring.
3. Step 3 – Reassemble the Nut, Snap Ring, Cam and Spring.
4. Step 4 – Preload the Spring and Assemble the Snap Ring and Nut.

What size belt does a 40 Series torque converter take?

40 series, length 33.87″, width 7/8″, used on many Manco karts and most Carter 40 series karts. 12346 Drive belt used on Manco model 710. 40 Series belt 7/8″ wide. Used on Comet 40 / 44 series torque converters, these belts are all 7/8″ wide.

Is a torque converter better than a centrifugal clutch?

As torque converters handle low torque ranges more easily, they’re most commonly used on off-road go-karts. They perform better at lower speeds and are ideal for stop-and-go situations. Clutches on the other hand are snappier and perform better at high speeds.

Why does my go-kart keep eating belts?

Kart Moves While Engine Is Idling (Torque Converter): Drive belt installed wrong (30 Series only, flat side of belt should be towards the engine) Wrong drive belt installed (a belt that is too short will cause the machine to “creep” at idle) Engine idle set too high. Pulleys not aligned (will also destroy belts)

Why does my go kart keep eating belts?

How tight should go kart belt be?

With the cover removed from the driver pulley, pull the belt past the crankshaft and ensure that there is a gap of about 1/8″ to 3/16″ between the crankshaft and the belt when it’s pulled. You should ensure that the go-kart belt fits within this range.

How do you measure a comet belt?

How to Select the Correct Comet Belt

1. Determine the Series Type. (
2. Measure the “Outer Diameter” (O.D.) of the driven pulley on the jackshaft.
3. Measure the “Center Distance”; which is the exact distance between the center of the engine crankshaft and the center of the jackshaft or secondary shaft.

How do you measure a torque converter belt?

Simply take a measuring tape and hold it against the outer plate of the pulley. Measure from one side of the plate to the opposite side. If you’re running a standard torque converter the diameter will either be 6-inches, 7-inches, 7.5-inches or 8.5-inches.

Which is better CVT or torque converter?

CVTs offer nearly an infinite number of gear ratios, meaning your engine is always working at peak efficiency, regardless of speed. Torque converter transmissions offer big torque at low revs, but are generally less efficient than single and dual-clutch transmissions.