How long does a Sunbeam heating pad last?
approximately 30 minutes to 2 hours
Sunbeam® heating pads are engineered to never exceed 176°F the temperature set by Underwriters Laboratory (UL). They will remain cool or hot for approximately 30 minutes to 2 hours, depending on variables such as air temperature.
How do you reset the Sunbeam heating pad?
We recommend you to reset your heating pad by unplugging and plugging it back in. Make sure to check the cord if it’s tightly connected and plug it into a wall outlet.
Why is my Sunbeam heating pad blinking red light?
The controller will blink red if the throw is disconnected or the internal heating wires have broken (open circuited). For me it went back into normal operation once I had reconnected the throw to the controller then reset it by unplugging the AC power plug then plugging it back in.
Can you sleep with Sunbeam heating pad?
You CAN lay on it, but, according to Sunbeam, that voids the warranty. It’s NOT a warning against getting burned, as I and most reasonable people would think; it’s because if you lay on it or lean against it, the machine will ultimately stop working.
What does the letter F mean on a Sunbeam heating pad?
The flashing F means it needs to be reset. I think there are directions on the Sunbeam website. I have had fairly good luck when it happens to unplug from the wall, the unplug from the pad. Wait 20 minutes and plug in the pad. Wait a few minutes and plug into the wall.
Why isn’t my Sunbeam heating pad working?
Unplug the power cord from the wall outlet. Check that the control is tightly connected to the module in the blanket. Re-plug the power cord into the wall outlet. On a digital control, you should see flashing symbols and the display on your control will clear.
Why is my heating pad not working?
The most common fix to heating pads is cleaning out the control unit on the cord. Unplug the heating pad, then use a screwdriver to open up the control unit. If parts are loose, tighten them. Otherwise, you may need to invest in a new heating pad.
Is it bad to use a heating pad all day?
It all depends on the level of pain and your tolerance to heat. Even so, if you use a heating pad on a high setting, remove after 15 to 30 minutes to avoid burns. On a low setting, you can use the heating pad for a longer period, maybe up to one hour.
What does F2 mean on Sunbeam?
times trying to reset, disconnect the power cord and contact Sunbeam Consumer Care. see less Q What does “F” ,”FF”, “F1” or “F2” mean on my Electronic Digital Control? A The digital controls are designed to notify you in the event that a problem has been discovered. by flashing “FF”, “F1” or “F2” on the display.