How do you drain a Jacuzzi j355?

How do you drain a Jacuzzi j355?

to drain your spa, perform the following steps:

1. Turn off power to spa at breaker.
2. Locate the drain valve on the front/lower plastic.
3. Attach a garden hose to the exposed threads.
4. Gently rotate the larger (rear) valve body 1/3.
5. Pull the larger (rear) body outward to open drain.
6. After the spa drains, perform steps 2-5 in.

What Jacuzzi model do I have?

The model and serial number is located in three places: On a label located on the back page of your Operating/Installation Instructions. (With the warranty information) On a white label located on the bath vessel near the pump/motor.

How do you turn the jets off in a jacuzzi?

If you have massage jets running with therapy pumps and the standard circulation jets you might have a button that says: Jets 1, Jets 2, and Jets 3. To toggle the pumps on and off, simply press the jets you would like turned off. That will switch off the therapy pump you indicated.

What’s the difference between a Jacuzzi and a hot tub?

The word “hot tub” is often used synonymously with the word “Jacuzzi,” but it turns out there are a few subtle but important differences between the two: Hot tubs are large tubs of hot water that can be used to relax and entertain. Jacuzzi is a trademarked brand of hot tubs and other products.

Where is the serial number on a Jacuzzi?

You’ll need the serial number of your hot tub, which can be found on a label on your warranty package envelope, or on the inside of the spa cabinet in the equipment area (remove the equipment door).

How do you unlock a Jacuzzi?

Spas using Spa Power systems You will need to hold the buttons down for about three seconds before the lock is activated. At this point, the touchpad beeps and displays “Keyboard Lock”. Unlocking: Press “Down”, then “Scroll”, “Down”, “Up” and finally “Scroll”.

What is the button on a Jacuzzi?

Some larger hot tubs may have up to three jet buttons on the control panel that allow you to adjust the speed and strength of your jets. In most cases, pushing the button the first time will turn them on a low setting and pushing it again will increase the speed.

What are the knobs on my Jacuzzi tub?

There there might be one or two knobs, those are used to regulate the amount of air, which in turn controls the amount of bubbles or the intensity of the jets. Some also have underwater disco lighting.

Is the J-300 collection a good jacuzzi?

Your Jacuzzi J-300 Collection spa is constructed to the highest standards and is capable of providing many years of trouble-free use.

How to close the air controls on a jacuzzi?

Jacuzzi logo side down to open or press the opposite side of button to close. note: To minimize heat loss, close all air controls (Jacuzzi logo up) when spa is not in use. Certain jets may not draw air when jets pump 1 is running in low speed;…

What causes a weak jet on a jacuzzi?

Page 40 8.8 Weak Or Surging Jets Weak or surging jets are usually caused by an insufficient water supply to the pump… Page 41 8.9 Pump Runs And Quits During Jet Mode This is usually a problem of the pump overheating. The pump motor…

How long does it take for a jacuzzi pump to turn on?

Approximately two minutes after power is applied to the spa, the first filtration/heating cycle turns on pump 1. An automatic five minute “blow-out” function also activates pump 2 for a period of five minutes to flush all lines. Then, after five minutes, pump 2 turns off and pump 1 continues to operate for the duration of the cycle.