How do you turn off the check engine light on a Toyota Matrix?

How do you turn off the check engine light on a Toyota Matrix?

1. Using a Scan Tool

1. Connect the scan tool to the onboard diagnostic connector. This is found under the steering column.
2. Press the READ button on the scan tool, and look for any error codes.
3. Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.

How do you reset the ECU on a Toyota Matrix?

There are 2 ways to reset the ECU. Disconnect the negative terminal for about 10-15 minutes then reattach. You can also pull the blue 15 amp fuse from under the hood. It is located near the huge 40 A fuse, reattach after 10-15 minutes.

How do you reset the maintenance required light on a 2005 Toyota Matrix?

How to Reset the Maintenance Required Light?

1. Turn Your Vehicle on. Your key should be switched to the on position and look on your dashboard.
2. Turn the Vehicle Off and Press the Trip Meter Reset Button.
3. Turn the Vehicle Back on.
4. Keep the Reset Button Pressed.
5. Release the Reset Button.

How do you reset a matrix?

While matrix is powered on, Hold in the RESET and SFT CLR buttons for five seconds. Release the RESET button. Release the SFT CLR button. It will take approximately one minute for the system to perform the software clear and then the time and date should come up on all monitors.

How long do I leave battery disconnected to reset check engine light?

Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. Secure the negative cable back to the terminal and cover it with the cap (if applicable). Disconnecting the battery will clear the error codes and reset the check engine light.

How do you reset check engine light on Toyota Matrix?

Basically, with the odometer appearing in the IP, turn off your car. Then press and hold the tripmeter reset button and turn the key to on. Count to ten, and the maintenance light will go out. Voila! You have just reset it. Check engine lights are not some trick Toyota puts in the car to make more money from service.

Can a check engine light be reset on a Toyota?

If there’s an issue with your Toyota, then the check engine light will come back on. If that’s the case, the only way to reset the check engine light is to get the problem that’s triggering the light fixed. Bring your Toyota to a mechanic, who will accurately determine why the check engine light is coming on in the first place.

How do I reset the maintenance due light?

Resetting the maintenance due light is detailed in the owner’s manual, it’s no secret. Basically, with the odometer appearing in the IP, turn off your car. Then press and hold the tripmeter reset button and turn the key to on. Count to ten, and the maintenance light will go out. Voila!

How can I remove the Check Engine light?

Press the READ button on the scan tool, and look for any error codes. Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.

https://www.youtube.com/watch?v=VcvvSC5zjwo