What is the average pedestrian walking speed?
Other studies have identified pedestrian walking speeds ranging from 0.6 to 1.3 m/s (2.0 to 4.3 ft/s). The Institute of Transportation Engineers (ITE) publication, Design and Safety of Pedestrian Facilities, even cited walking speeds up to 2.4 m/s (8 ft/s).
What is the suggested walking speed from the Manual of Uniform Traffic Control Devices MUTCD in feet per second?
MUTCD DESCRIBES A “NORMAL WALK SPEED OF 1.2 METERS (4.0 FEET) PER SECOND” FOR USE IN TIMING THE PEDESTRIAN CLEARANCE PHASE AT A TRAFFIC SIGNAL. THERE ALSO IS AN UNSPECIFIED SUGGESTION TO USE SLOWER SPEEDS WHEN SLOWER PEDESTRIANS “ROUTINELY” USE A CROSSWALK.
How do you calculate pedestrian crossing time?
Pedestrian clearance time is computed as the crossing distance divided by the walking speed. When the pedestrian clearance interval begins, pedestrians should either complete their crossing if already in the intersection or refrain from entering the intersection until the next pedestrian walk interval is displayed.
What is pedestrian recall?
Pedestrian Recall is a walk mode that is programmed into signal controllers. The start of pedestrian green (walk indication) coincides with the start of green for the through movement Page 11 3 parallel to the pedestrian movement and is called once per cycle.
What is a good pace for walking?
Many fitness experts consider a brisk walking pace to be 100 steps per minute or 3 to 3.5 miles per hour. A brisk pace is relative since it refers to your level of exertion, which depends on your fitness level. In order for it to be considered a brisk pace, you need to raise your heart and breathing rate.
What is a good walking pace per km?
For a person with excellent fitness, an approximate moderate walking pace: 15 minutes per mile (4 miles per hour) 9 minutes per kilometre (6.4 kilometres per hour)
How long is a WALK signal?
approximately 7 seconds
The WALK signal will be illuminated for approximately 7 seconds. A pedestrian will begin to cross the street just as the DON’T WALK signal begins to flash.
What walking speed in feet second is recommended in the Mutcd 2009 edition?
The 2009 edition of the Manual on Uniform Traffic Control Devices (MUTCD) recommends a pedestrian walking speed of 3.5 feet per second for use in the timing of pedestrian clearance intervals at signalized intersections (reduced from 4.0 feet per second in the 2003 edition).
Which side of the road should a pedestrian WALK?
left
Pedestrians must always walk against traffic. Walk as close to the left side of the road possible using the shoulder or sidewalk, if available. When attempting to cross, always look left, right, and left again.
What is a leading pedestrian interval?
Leading Pedestrian Intervals or LPIs provide 3 to 10 seconds of advance WALK signal only for pedestrians, where vehicles are traveling in the same direction or turning right or left across the crosswalk.
What is minimum green time?
The minimum green time is the minimum assured green that will be displayed. It is established to allow vehicles that are stopped between the detector on the approach and the stop line to get started and move into the intersection.
How long does 2km take to walk?
Kilometer: A kilometer is 0.62 miles, which is also 3281.5 feet, or 1000 meters. It takes 10 to 12 minutes to walk at a moderate pace.