What is a engineer directional compass?
An engineer lensatic compass, also known as a hand compass or sighting compass, allows you to take bearings on physical landmarks which can then be used to determine your exact position on a map or navigate toward the landmark even when it can no longer be seen.
How much is a engineer directional compass?
MSRP $15.99
| ITEM # | UPC # | Price |
|---|---|---|
| 51640 | 846271006132 | 15.99 |
How do you use a directional viewing compass?
Place the compass flat on your palm, with the direction of travel arrow pointing towards where you want to go. Twist your compass dial so that the orienting arrow lines up with the red end of the magnetic needle.
What type of compass does the military use?
lensatic compass
A lensatic compass is often referred to as a military compass, and is typically used by the U.S. Military. The lensatic compass is comprised of different parts compared to a baseplate compass.
How do you open an engineering compass?
Open the compass by folding down the thumb loop and opening the front cover until it is flat with the base of the compass. Raise the rear sight until it is perpendicular to the base. Hold the compass by placing your thumb through the thumb loop and extending the index finger along the side of the base.
How do you use an engineer compass?
Use the engineer compass to measure the azimuth to take a bearing or direction. Open the engineer compass until the cover is 90 degrees to the compass case. Tilt the lens bracket approximately 30 degrees from the perpendicular position of the compass. Check that the dial is floating freely.
What is the wire for on a compass?
Lensatic compasses are made up of three parts: cover, base, and reading lens. The cover is used to protect the compass and also incorporates the sighting wire—which helps you determine direction.
How many degrees is north on a compass?
360 degrees
Since a compass represents 360 degrees, north can be though of as zero(0) or 360. By subtracting 15 degrees from 360 degrees, you find that true north would be what appears on this compass as 345 degrees (half way between 360 and 330).
How do you use a directional compass?
Hold the compass horizontally in front of you with the direction of travel arrow pointing away from you. Use this arrow to guide you to your destination. Turn your body until the north end of the magnetic needle is aligned with the orienting needle, and you’ll be properly oriented toward the destination on the map.
Use the engineer compass to measure the azimuth to take a bearing or direction. Open the engineer compass until the cover is 90 degrees to the compass case. Tilt the lens bracket approximately 30 degrees from the perpendicular position of the compass. Check that the dial is floating freely.
What is a compass engineer?
According to United States Army Corps of Engineers, the engineer compass is also called a lensatic compass. Use the engineer compass to find the direction by lining up the compass with an object.