How do I setup my Dlink DIR 825?

How do I setup my Dlink DIR 825?

Configuration for D-Link DIR-825

1. Visit the router’s IP address (http://192.168.0.1) in a new browser window.
2. Enter the router password.
3. Click on the Manual Internet Connection Setup button at the bottom.
4. Enter the OpenDNS addresses in Primary DNS Server and Secondary DNS Server fields.

How do I reset my route to factory settings?

To reset your router:

1. Locate the Reset button on the back of your router.
2. With the router powered on, use the pointed end of a paperclip or similar object to press and hold the Reset button for 15 seconds.
3. Wait for the router to fully reset and power back on.

How do I fix my router after resetting it?

After pressing the Reset button, unplug and re-plug the router’s power adapter. NOTE: The Power LED of the router will keep on blinking for a few seconds after resetting as it is still trying to stabilize. However, if the Power light still isn’t solid after a minute, powercycle the router.

How do I log into my Dlink DIR 825?

Start a web browser. In the address bar of the web browser, enter the IPaddress of the router (by default, 192.168. 0.1). Press the Enter key.

How do I get into Dlink router settings?

Step 1: Open your web browser and type in http://dlinkrouter.local. or type in the IP address of the router (default – http://192.168.0.1). Step 2: Enter or select the username (admin) and enter your password (blank by default), and then click OK or Log In.

How to hard reset D-Link dir-825 Rev B1 router?

How to hard reset (factory reset) D-Link DIR-825 rev B1 : You can hard reset your D-Link DIR-825 rev B1 with ways bellow. With the reset button. Locate the reset button on the back off the router.

How do I Reset my D-Link router to factory settings?

To perform a factory reset, please follow Below steps. Power on the D-link Router, place a paper clip or Pin into the hole on the back of the Router labeled Reset. Hold paper clip or pin down for 10 to 15 seconds and release. The Router will reboot on its own. Once the WLAN light stops blinking, the Router is reset.

What’s the default password for the D-Link Rev B1 router?

D-Link DIR-825 rev B1 default Login & Password, factory settings : Default Gateway IP: 192.168.0.1. D-Link login instructions. Default username: admin. D-Link router default password list. Default subnet mask: 255.255.255.0. Default DNS server: 192.168.0.1.