How do you remove a GM power steering pulley without a puller?

How do you remove a GM power steering pulley without a puller?

Can You Remove the Power Steering Pump Pulley Without a Puller?

1. With the pump taken off the vehicle, place it in a vice and use a piece of metal pipe and a hammer to tap the wedge between the pulley and the pump.
2. Heat the center of the pulley with the blowtorch and pull it off.

What tool is needed to remove and install a power steering pump pulley?

Using an impact wrench or regular socket and ratchet, remove the bolts that hold the power steering pump onto the bracket or the engine block. Usually there are two or three bolts that need to be removed.

How do you remove a pulley without a gear puller?

There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.

What tool is used to remove crankshaft pulley?

A half-inch drive impact gun might be a great tool for removing a stubborn crankshaft pulley bolt. A torque wrench has also been proven to be a helpful tool for correctly securing it.

How do I remove a crankshaft pulley without a puller?

You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.

How much to have power steering belt replaced?

On average, a power steering belt is going to cost anywhere from $11 to as much as $48 without any sort of professional installation.

How much to replace power steering pump?

Power Steering Pump Replacement Cost Labor costs are estimated between $167 and $211 while parts are priced between $347 and $502. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed. For a more accurate estimate based on your location, use our Fair Price Estimator.

How do you remove Pully from power steering pump?

To remove the pulley from the power steering pump, a special power steering pump pulley puller is required. Remove the power steering belt. Loosen the tensioning bolt and push the power steering pump toward the engine. Then remove the belt.

How do you install a power steering pulley?

Install a new power steering belt on the pump pulley and new crankshaft pulley. Adjust the belt as needed. Reattach the fan belt and alternator belt to the triple pulley and adjust the belts. Fill the power steering pump with fluid.