What does a mil Eliminator do?

What does a mil Eliminator do?

PEP™ MIL Eliminators or Malfunction Indicator Light Eliminators, are electronic modules that prevent the “Check Engine” or “Service Engine Soon” light from coming on when an offroad H or X pipe is installed on a late-model vehicle with OBD-II emissions systems.

How do you bypass a rear oxygen sensor?

To get around this, you can bypass the rear O2 sensor by generating a false sensor reading using a dummy O2 sensor.

1. Jack up the front of your vehicle using the floor jack.
2. Place a jack stand under each of the front pinch welds and lower the vehicle onto the stands.
3. Climb under the vehicle and locate the rear O2 sensor.

Can you delete O2 sensors?

Unplug the O2 sensor from the wiring harness, and tie the green wire into a loop. You can remove the O2 sensor from the vehicle with a wrench, but you must have a plug to thread into the O2 sensor bung, to keep exhaust gasses from escaping the manifold or pipe.

What happens if you remove the O2 sensor?

With the O2 sensor removed, your ECU can no longer calculate how much fuel should be injected. The ECU will fallback to its default value and always inject the same amount of fuel every time. This could cause either low performance or horrible fuel economy.

What happens if I unplug my O2 sensor?

Can a Diablo tuner turn off O2 sensors?

Any Diablo tuner that uses CMR tuning can disable the sensors.

What is a dummy 02 sensor?

What is a dummy 02 sensor? A dummy O2 sensor is a fake one that does readings like a normal one. A dummy one sends the cars computer the proper information that a normal one would send if it were reading correctly. All you have to do is locate your cars current O2 sensor and unplug it.

What will happen if I unplug my O2 sensors?

What is a dummy O2 sensor?

A dummy O2 sensor is a fake one that does readings like a normal one. A dummy one sends the cars computer the proper information that a normal one would send if it were reading correctly. Dummy O2 sensors are easy to use. All you have to do is locate your cars current O2 sensor and unplug it.

How do you bypass an O2 sensor?

How to Bypass Oxygen Sensors

1. Raise your vehicle onto jack stands.
2. Place jack stands underneath the front pinch welds located underneath the front doors (underneath the vehicle) and lower the vehicle onto the stands.
3. Remove the electrical plug from the O2 sensors underneath the vehicle.