How do I fix error code P0336?

How do I fix error code P0336?

What repairs can fix the P0336 code?

1. Replacing a damaged reluctor wheel.
2. Repairing or replacing a damaged crankshaft position sensor wiring or circuitry.
3. Repairing or replacing damage or corrosion of the crankshaft position sensor connector.
4. Repairing or replacing the crankshaft position sensor wiring harness.

What does P0336 code mean?

What Does P0336 Mean? The ECM relies on the crankshaft position sensor to know when to fire the injectors and spark plugs. When code P0336 is set, the ECM is reading an irregular voltage coming from the crankshaft position sensor.

What are the symptoms of a failing crankshaft position sensor?

Symptoms of a Bad Crankshaft Position Sensor

• Your Check Engine Light is Blinking.
• It’s Difficult to Get Your Vehicle to Start.
• Your Vehicle is Stalling and/or Backfiring.
• The Engine is Making Your Vehicle Vibrate.

How do you relearn a crankshaft position sensor?

to perform the relearn, proceed as follows:

1. Set the parking brake and block the drive wheels.
2. Start the engine and make sure that the engine coolant temperature is at least 158 degrees F.
3. Turn the engine off for at least 10 seconds.
4. Select the crankshaft position variation learn procedure (CASE Learn)on your scanner.

Where is the crankshaft position sensor located?

The crankshaft sensor is usually located near the bottom of the block, toward the front of the engine. In most cases, you’ll find it behind the harmonic balancer. In some vehicles, you might find the crankshaft sensor behind the timing cover, near the bottom of the block, though this is rare.

What is the code for crankshaft position sensor?

It works hand in hand with the reluctor ring that creates a square wave voltage signal that the ECM interprets as the crankshaft position. Trouble code P0335 is set whenever the ECM does not sense crankshaft pulses or senses a problem with the pulses in the output with Sensor “A” Bank 1.

What is ignition trigger?

The ignition trigger is an electronic mechanism of the vehicle’s engine management system, commonly found, in one form or another, on a large number of road going cars and trucks. Most ignition triggers operate as a magnetic sensor that is “triggered” as the unit rotates.

Where is crankshaft sensor located?

The crankshaft sensor is usually located near the bottom of the block, toward the front of the engine. In most cases, you’ll find it behind the harmonic balancer.

Can I drive with a bad crankshaft position sensor?

”It is not safe to drive with a bad crankshaft position sensor because if the crankshaft position sensor is faulty, it can no longer supply the engine control unit with correct information about the position of the crankshaft.

How do you align a crankshaft sensor?

Remove the right front wheel well liner.

1. Rotate crankshaft until cylinder 1 is 45 degrees BTDC.
2. Working above the right drive axle, remove the crankcase timing plug.
3. Install the TDC timing peg finger tight.
4. Hole on crankshaft pulley will align with hole on timing cover.