How do you use Xstamper?

How do you use Xstamper?

To use an Xstamper gently press the handle against the paper. Unlike conventional stamps, a hard strike or rocking motion is not necessary. A light press to the stamping surface will ensure the highest quality impression. Allow a few seconds between stamping for maximum ink flow.

How do you refill a Xstamper Quix?

How to Re-ink

1. Remove cap and place face down.
2. Hold stamp handle firmly and pull out die holder from handle.
3. Place die holder on top of removed cap with impression die facing down. Hold die holder firmly and remove top plug.
4. Place drops of ink into the opening.

How do I refill my Xstamper 8104?

You will remove the small screw to expose the “inkwell” place 3 to 4 drops of ink into the inkwell and replace screw back into the stamp. Recommendations: Re-Ink your stamp overnight to allow ink to fully absorb into the stamp pad. No ink pad Necessary, each band is pre-inked.

How do I refill my Xstamper eco green stamp?

1. First, push down slightly on the top of the stamp and push the white locking buttons on either side of the stamp. This will allow the ink pad to slide out.
2. Second, carefully slide the ink pad out.
3. Third, put a few drops of the same color ClassiX® refill ink onto the pad.

How do you clean Xstamper stamps?

Custom-made Xstamper stamps should be stored in a dust-free environment. The tacky side of any plastic tape can be used to remove dust or paper fibers which may accumulate on the stamp surface. Plain rubbing alcohol on a dust free cloth can be used on the stamp surface to clean any dirt that may build up.

How do I refill my Xstamper Eco Green?

How do you clean an Xstamper?

How do you open a Xstamper?

Remove the white cap on top and place 2-4 drops of the same color ink in the opening in the center of the mount. Put a few drops of the corresponding color ink in the XpeDater base and a few in the travel cap as needed. Firmly hold the teal handle and the white Impression FrameTM and pull apart.

How do you remove ink from a stamp pad?

Red Ballpoint Ink Or Stamp Pad Soak in solution of 1 quart warm water, 1/2 teaspoon liquid hand dishwashing detergent and 1 tablespoon ammonia for 30 minutes. Rinse with water. Soak in a solution of 1 quart warm water and 1 tablespoon white vinegar for 1 hour. Rinse with water.