How do you reset the code 82 on a Chevy Cruze?

How do you reset the code 82 on a Chevy Cruze?

How to Reset Oil Life: Chevrolet Cruze 2011-2016.

1. Turn the ignition to run (one position before starting engine).
2. Press the DIC menu button on the turn signal lever to enter the vehicle information menu.
3. Press the SET/CLR button to reset the oil life to 100%.
4. Press the SET/CLR button to confirm.
5. DONE!!! :D.

How do I reset my Chevy Cruze computer?

To reset the ecu or computer in your 2013 Chevy cruze vehicle, disconnect the positive battery cable and remove your ecu relay or fuse. Wait two to three minutes and reinsert the fuse and reconnect battery cables and your vehicle’s ecu should be reset.

What does code 82 mean in a Chevy Cruze?

In this case, a Code 82 on my Chevrolet Cruze means I’m in need of oil maintenance / oil change. If you have this code flash up on your dash be sure to contact your local dealership to correct any possible issue.

How do you reset the service light on a Chevy?

Within five seconds of turning the key, depress the accelerator fully to the floor three times. 3. Watch for the oil light to flash and turn off. If the oil change light does not turn off, turn the key to the off position and retry the process.

What does code 82 mean?

oil change maintenance code
Code 82 is the oil change maintenance code. I happen to know this because my girlfriend has a 2014 Spark and the code is easy to reset. Search You Tube for the exact procedure but you turn the key on and select menu for the reset.

How do I reset my car without disconnecting the battery?

How To Reset Car Computer Without Disconnecting Battery

1. 3.1 Step 1: Open the hood and disconnect the battery.
2. 3.2 Step 2: Locate the car’s fuse box and remove the fuse.
3. 3.3 Step 3: Reinstall the fuse and reconnect the battery terminal.
4. 3.4 Step 4: Start the vehicle and perform a test run.

How do you clear the codes on a Chevy Cruze?

Turn the vehicle on for a minute. Then, turn it off. Do this three times in a matter of a few minutes. That resets the code.

How do I get rid of code 82 on a Chevy Spark?

Code 82 in the 2014 Chevy Spark corresponds with the oil change maintenance code. To reset it, turn the ignition to the ON position. Navigate to “oil life” on the display menu where You will see “reset”. Keep pressing the set button until the oil life is set to 100 percent.

What does code 82 mean on Chevy Cruze LT?

Not the American mile. Code 82 is for the oil life monitor, wasn’t reset at oil change. 1. Turn on ignition. 2. Push Menu button on the turn signal switch. 3. Use adjustment wheel and select menu – Vehicle Information System. 4. Use adjustment wheel and select menu – Oil Life System  5.

How to change the oil on a Chevy Cruze?

1. Turn on ignition. 2. Push Menu button on the turn signal switch. 3. Use adjustment wheel and select menu – Vehicle Information System. 4. Use adjustment wheel and select menu – Oil Life System  5. Push SET/CLR button on the turn signal switch and push brake pedal at same time. Hmm.

Why do I get a code 82 after an oil change?

The Code 82 showing after an oil/filter change normally indicates that the dealer ‘forgot’ to reset the oil counter setting. Why adding STP or similar should ‘reset’ the counter setting is a puzzler to me. Also your comment about oil level going down.