How do you adjust the tension on a compound bow?
Insert the short arm of an Allen wrench (most commonly a 3/16 size, usually included with the bow) into the bolt and make sure it is properly slotted. Then, turn the wrench either clockwise to tighten the bolt or counterclockwise to loosen it. Adjust the tension of each arm of the bow to the preferred weight.
How much does it cost to get a compound bow adjusted?
If you get new arrows, a new string or a new arrow rest, or if you notice string stretch or change your draw weight or length, it’s smart to get your bow tuned. A typical bow tuning service costs $40 to $70 and takes about an hour.
How much should I adjust my draw length on a compound bow?
The changing out of the modules usually requires a hexagonal wrench and can be done without pressing the compound bow. While certain companies will offer lifetime modules changes, most new modules have to be purchased. Average cost is $8 to $25.
Does scheels work on bows?
With our archery service shop, you can bring your bow in for maintenance or repair, and leave with it working like new. Our archery service shop provides paper tuning to examine the flight of your arrow and bow tune-ups to make sure everything is in working order before you leave to get ready for the hunt.
How often should I restring my bow?
In general, we recommend a bow rehair every six months to a year, ideally at the beginning of the winter and summer. Rehairing maintains the physical condition of the bow and enhances playability.
How far can a 20 lb bow shoot?
How Far Can a Bow Shoot? | Ranges by Draw Weight (With Chart)
| Bow Type | Draw Weight | Effective Range |
|---|---|---|
| Recurve bow | 30 lbs | 15 – 20yds |
| 35 lbs | 20 – 25yds | |
| 40 lbs | 25 – 30yds | |
| Compound bow | 30 lbs | 30 – 40 yards |
How hard is it to pull back a 40 pound bow?
The draw weight is basically, “How strong do I need to be in order to pull this thing back?” For a recurve bow, it’s measured by pulling back to 28 inches. So for a 40 lb bow, it means that it takes 40 lbs of force to pull back the string 28 inches for a recurve.
How to adjust the tension on a compound bow?
1 Tighten or loosen the limb bolts one full rotation at a time. This will help you keep track of the level of tension in each of the limbs. 2 On most compound bows, one rotation of the limb bolt translates to roughly a pound and a half of weight. 3 Remember to adjust the tension equally on both limbs.
What are the draw lengths of a Pearson compound bow?
The approximate draw lengths are SAH- 24, SDH- 27, SEH- 28, SFH- 29, SGH- 30 and SHH- 31 inches in draw lengths. Please don’t buy this bow unless it fits your draw length. There are two string posts on the cam to fine tune the draw length +/ 1/4 inch any additional fine tuning will need to be done with the string length.
How do you lower the draw weight on a compound bow?
If you are looking to lower the compound bow draw weight, first you need to raise it to the maximum (by tightening the limb bolts). Next, you should unscrew the limb bolts one 360° revolution (counterclockwise). Use a bow scale to check the poundage, and continue loosening the bolts one 360° at a time, until you find the desired draw weight.
Where are the limb bolts on a compound bow?
To do this, first locate the limb bolts on your bow. These are usually near the center of the bow, and lie in big circular knobs. The draw weight on a compound bow can be changed by adjusting both limb bolts, which are usually locked into the riser with locking bolts located just below the top limb or above the bottom limb.