Can you join a domain on a different subnet?

Joining AD domain (when routing is ok) is DNS dependent. make sure the DNS server is doing name resolution for the new subnet and you are fine. As mentioned above dont forget to add new Subnet to the Sites and services console.

Can DNS server be on different subnet?

You can absolutely have DNS servers on different subnets.

Do you have to be on the same network to join a domain?

You can use offline domain join to join computers to a domain without contacting a domain controller over the network. You can join computers to the domain when they first start up after an operating system installation.

How do I join a domain from outside the network?

Connect the VPN client.
Right click on “Computer” (formerly My Computer) and choose properties.
In the resulting window select “Change Settings”
Slect “Change” again.
Enter the corporate internal Domain name, such as MyDomain.local in the Domain box and click OK.

Can I join domain with IP address?

The IP address you’ve configured (or leased) should be good enough to enable you to connect to one of the Domain Controllers on your Domain. The DNS server must hold a zone with the exact name of the AD domain you’re trying to join. It also must hold 4 SRV folders (you can tell by the “_” in their name).

How do I join an IP address to a domain?

Set a Static DNS server address

Open the Control Panel.
Select View network status and tasks or Network and Sharing Center.
Select Ethernet.
Select Properties.
Select IPv4, then Properties.
Select Use the following DNS server addresses.
Enter the Domain Controller / DNS Server’s IP Address, then click OK.

Can a domain controller have multiple IP addresses?

Sometimes it’s unavoidable to run an Active Directory domain controller (DC) on hardware that is configured with two network cards (NICS). While not a recommended configuration, it is possible to run a domain controller with two IP addresses.

Does LAN use DNS?

With LAN DNS, the Vigor router can act as a DNS server and answer the DNS queries from LAN clients. We may designate up to 20 hostnames to the servers on the LAN network, so the LAN clients can access the services via an easy-to-remember name instead of IP addresses. Here we use an FTP server as an example.

What is the difference between workgroups and domains?

The main difference between workgroups and domains is how resources on the network are managed. Computers on home networks are usually part of a workgroup, and computers on workplace networks are usually part of a domain. In a workgroup: All computers must be on the same local network or subnet.

What is the basic requirement is needed to configure and join to domain?

To join a domain you will need some permissions. Firstly, you must have the credentials (username and password) of a local administrator and secondly the credentials of a domain user who has the right to join the computer into the domain. Such a user may be a domain administrator or a user with delegated permissions.

Can you join domain over VPN?

Yes it’s possible, you’ll need to join the vpn before logging into the computer. Once on the computer, log into the computer and if dns is properly configured, you’ll be able to join the domain and then log in with you domain account to the remote computer.

Do you need a DNS server for multiple subnets?

DNS server itself can manage multiple subnets in forward lookup zones automatically. You have no need for an additional DNS server. But you may think about having at least 2 DC/DNS/GC per domain for fail over and redundancy and that all domain machines use them on the NIC.

Can a subnet be joined into a Super subnet?

If so you need to change your subnet mask to include both subnets then they will be joined into a super subnet. Was this post helpful? Thanks for your feedback! I think it is but any ideas how to resolve this by DNS

Can A.8 domain join A.7 domain?

The domain controller is on the .7 network. but computers on the .8 domain cant join the domain unless i move them into the .7 network. I currently use server 2003. i know there are some setting i need to do on the sever.i already configured the DNS reverse lookup zone to accept .7 but its not working.

Is it OK to join an ad domain?