What is standard NPT thread size?
NPT and NPTF pipe threads – dimensions according ANSI/ASME B1. 20.1/3
| NPT – American Standard Pipe Thread Taper 1) | ||
|---|---|---|
| Pipe Size (inches) | TPI | Nominal Outside Diameter Pipe OD (inches) |
| 3/8″ | 18 | 0.675 |
| 1/2″ | 14 | 0.840 |
| 3/4″ | 14 | 1.050 |
What is a 1/2 NPT thread?
Basic Dimensions, American National Standard Taper Pipe Threads, NPT, (ANSI B2. 1-1968)
| Nominal Pipe Size | Outside Diameter of Pipe | Threads per Inch |
|---|---|---|
| 1/4 | 0.540 | 18 |
| 3/8 | 0.675 | 18 |
| 1/2 | 0.840 | 14 |
| 3/4 | 1.050 | 14 |
What does NPT stand for in threads?
American National Pipe Tapered Thread
The best known and most widely used connection where the pipe thread provides both the mechanical joint and the hydraulic seal is the American National Pipe Tapered Thread, or NPT. NPT has a tapered male and female thread which seals with Teflon tape or jointing compound.
What is NPT fitting?
NPT (or National Pipe Taper) is a U.S. standard for tapered threads widely used on pipes and fittings for over 100 years. NPT connections rely on thread deformation- a metal to metal sealing design where the threads of the connectors themselves form together.
How can I tell what NPT threads I have?
To determine the NPT size, with a caliper, measure the diameter of the 2nd or 3rd thread on your pipe, fitting or valve as shown below. Find the caliper measurement in the chart and cross reference the nominal NPT pipe size. Don’t get confused, the actual measurement is not the same as the NPT pipe size.
What is the difference between NPT and BSP?
Both NPT and BSP are pipe thread standards for screw threads used on pipes and pipe fittings to seal pipes. With NPT, the peaks and valleys of the threads are flat. In BSP, they are rounded. Secondly, the NPT angle of the thread is 60 degrees and the BSP angle is 55 degrees.
Is line pipe thread the same as NPT?
“Line Pipe Threads” are taper threads similar to NPT threads and are used extensively in the flow line pipes.
What is a female NPT?
Sanitary Stainless Steel Fittings National Pipe Taper (NPT) are a standardized fitting that is commonly used for joining pipe. Due to the tapered threads (wider diameter at the base of the threads, similar to a trapezoid) the male fitting will tighten the further it is threaded into the female.