How do you reset a Zanussi washer and dryer?
Press and hold, together, the start button and the button to the left of it. While holding, turn the dial 1 click clockwise. The lights flash, release the buttons and the lights scroll. Now, turn the dial clockwise through each position till you get to off again.
Why is my Zanussi washing machine not working?
If the appliance is still dead, unplug the appliance again and check the fuse in the plug. If no method of checking the fuse exists, replace it with a known working 13 Amp fuse. If the appliance is still not working, please contact your local Authorised Service Center. Call 03445 611 611 to arrange a service call.
Can you reset a Zanussi washing machine?
Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn). Try to wash normally.
How dO I reset my washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
Why is my washing machine not finishing?
Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining. The pump could also be to blame if your washer is failing to drain.
Is there a reset button on a washing machine?
Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. Some machines have a button you push to reset its motor. On a machine without a reset button, unplugging the washer and then plugging it back in often serves as the means to reset it.
How do I find my Zanussi error code?
Error codes on Zanussi washing machines will be displayed in two different ways. If your machine has an LCD display you’ll see the letter E (E is for Error) followed by two numbers. If your machine has no LCD display however, combinations of LEDs on your machine will flash.
How do you clean the filter on a Zanussi washing machine?
Open the door to the fluff filter and place the drip tray underneath. Empty any water out of the machine by opening the drain hose next to the filter. Remove the filter by turning it anti-clockwise (several times firmly by hand). Clean the filter and pump housing under running water and refit the filter.