Why is my kreepy krauly not moving?

Why is my kreepy krauly not moving?

If Kreepy Krauly is not moving or not pulsating. Check that the main drain and all suction lines are closed, except for the suction line to which Kreepy Krauly is attached (usually a skimmer). Check for debris in the filter or [pump basket]. Check for debris in Kreepy Krauly flapper.

How do you use Pentair kreepy krauly?

1. Turn off the pool’s water filtration pump.
2. Place the Kreepy Krauly into the shallow end of the pool and allow it to sink to the bottom.
3. Fill the Kreepy Krauly hose with water from the garden hose.
4. Connect the water-filled hose to the pool inlet hole, or to the skimmer hole if you do not have a dedicated inlet.

Where do weights go on kreepy krauly hose?

Hose weight placement depends on the depth of the pool. For pools 4′ deep or less, use 1 hose weight 4″ to 12″ from the cleaner. For pools of 4-7′ deep, use 2 weights, one 4″ to 12″ from the cleaner and one 6′ from the cleaner. For pools from 8′ to 12′ deep, use a third weight, placed 10 ft.

Why is my automatic pool vacuum not moving?

If your robotic pool cleaner stops moving, check the power cord. It may not be plugged in properly or there may be a problem with the power supply. Check the power supply to make sure the indicator light is on. If it is and the pool cleaner is still not moving, then the problem lies with the cleaner.

Why does my manual pool vacuum gets stuck?

If You’re Using a Manual Pool Cleaner: If you’re using a manual cleaner you’ve got a great deal of control over the cleaner head, especially if you’re in the water using a short pole. If the suction is too strong, pushing the cleaner with a long pole virtually guarantees it will get stuck.

Can you leave robotic pool cleaners in the pool?

Leaving the cleaner in the pool 24/7 increases its exposure to corrosive chemicals in the water, such as chlorine or shock. Over time, these chemicals break down parts in the cleaner and discolor the cleaner. The truth of the matter is – everyone leaves them in the pool, pretty much all the time.

What setting should my pool filter be on to vacuum?

To begin vacuuming your pool:

1. If you have a sand filter and are vacuuming to waste, set filter to “waste” option.
2. Otherwise, leave setting on “filter” and turn pump on to begin vacuuming.
3. Vacuum your pool just as you would vacuum your living room, picking up debris or algae as you go.