What does an Epson printer maintenance box do?

What does an Epson printer maintenance box do?

The maintenance box stores ink that gets flushed from the system during print head cleaning. When an ink cartridge is expended or the maintenance box is at the end of its service life, you need to replace it.

Can you clean Epson maintenance box?

Such boxes can not only be cleaned and replaced with absorbent material, but do not have to be thrown away.

Can you reuse Epson maintenance box?

Do not reuse a maintenance box that has been removed and left uninstalled for more than a week. Keep the maintenance box away from direct sunlight. Note: You cannot print or clean the print head while the maintenance box is full, but you can perform tasks that do not require ink, such as scanning.

How do I change my maintenance box?

Replacing a Maintenance Box

1. Remove the new maintenance box from its package.
2. Open the document cover.
3. Open the control panel.
4. Loosen the screw with a flat-head screwdriver until the maintenance box cover comes off the printer.
5. Remove the maintenance box cover.
6. Remove the used maintenance box.

How do I reset my Epson maintenance box?

The procedure is simple: take the maintenance box out and find the chip. Put the chip on this resetter and press down. Hold it for few seconds and the counter will be reset to zero.

How do I clear my Epson maintenance tank?

Stylus Pro 4000 Maintenance tank reset

1. Turn off printer.
2. Hold down the three leftmost arrow buttons: [left-arrow] [down-arrow] [up-arrow]
3. Turn on printer.
4. Release buttons.
5. New menu appears.
6. press up/down arrows to get to the “Clear Counters” menu.
7. press RIGHT.
8. press up/down arrows to get to the “Maintenance Tank” menu.

How do I change the maintenance box on my Epson WF 4720?

Caution:

1. Make sure the product is not printing.
2. Remove the new maintenance box from its package.
3. Press the tab on the maintenance box cover and remove it.
4. Grasp the maintenance box as shown and pull it out of its holder.
5. Place the used maintenance box in the plastic bag that came with the new maintenance box.

How do I change the maintenance box on my Epson WF 3540?

Replacing the Maintenance Box

1. Press the power button to turn off the product.
2. Remove the new maintenance box from its package.
3. Press the tabs and remove the duplexer (rear cover).
4. Grasp the maintenance box as shown and pull it out of its holder.

How do I bypass Epson maintenance error?

Use printer buttons to reset For more general errors, users may reset their printer by pressing and holding the Stop, Maintenance, and Power buttons all at the same time. Other Epson models, such as the RX620, require you press and hold the Stop, B&W, and Power buttons simultaneously.