How do I set up NanoStation 2?
Make sure the Nanostation 2 (Nano for short) is connected to your computer’s network card with network cables, via the power injector (supplied with 12V either from the included wall-wart or another 12VDC source). There should then be at least one LED lit on the back of the Nanostation.
How do I reset my NanoStation Loco M2?
Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the NanoStation is powered on. Alternatively, a remote reset button is located on the bottom of the PoE Adapter.
What is the use of nano station M2?
The NanoStation®M can be deployed for Point-to-Point (PtP) bridging, wireless connectivity to a video surveillance system, or use as an airMAX® CPE. With software-enabled PoE output, the secondary Ethernet port can power an external device, such as a PoE security camera, for seamless IP video integration.
How does a Nanostation work?
We install a wireless device (either a Ubiquiti Nanostation M5 or Ubiquiti Nanostation Loco M5 depending on location) on the outside of your premises which then points to our network of repeater stations. This then passes the signal back to our core router, which then passes it to the internet.
Can a Nanostation Loco m2 work as a WiFi access point?
Airmax /TDMA is not compatible with the default 802.11 Wifi standard for Access Points. So that’s why, by default, if you setup a nanostation Loco M2 to behave as a Wireless Access Point without disabling Airmax, none of your devices will authenticate. Screenshots.
How big is a nanostationlocom2 / locom5 / M9?
NanoStationlocoM2/M5/M9 Dimensions locoM9 164 x 72 x 199 mm (6.46 x 2.83 x 7.83″) locoM2/locoM5 163 x 31 x 80 mm (6.42 x 1.22 x 3.15″) Weight locoM9 0.9 kg (31.75 oz)
What does the led mean on The Nanostation m2?
The LED will light steady green when an active Ethernet connection is made to the Main/LAN port and flash when there is activity. (NanoStation M2/M3/M5 only) The LED will light steady green when an active Ethernet connection is made to the Secondary port and flash when there is activity.
Where is the reset button on the nanostationlocom2?
Alternatively, the device may be reset remotely via a Reset button located on the bottom of the PoE adapter. * The Main port is labeled LAN on the NanoStationlocoM2/M5.