What is ASR subframe?
Designed in 2004, the ASR rear subframe brace has come a long way from its first introduction into the market. The subframe brace is used to reinforce the thin oem sheet metal rear subframe on Honda/Acura vehicles. This brace was designed with proper fitment in mind and each brace is quality checked.
What is a subframe brace for?
HARDRACE Rear Sub-frame Brace are designed to stiffen up the chassis and reduce vehicle chassis flex. This is why HARDRACE Rear Sub-frame Brace can maximizes the performance of the suspension and brings better handling feeling and quicker response.
Will Ek subframe brace fit EG?
EG would not fit EK and vice versa. only DC`s are straight fit to EG in most parts.
What is a subframe base?
A subframe is a structural component of a vehicle, such as an automobile or an aircraft, that uses a discrete, separate structure within a larger body-on-frame or unit body to carry certain components, such as the engine, drivetrain, or suspension. There are generally three basic forms of the subframe.
Is subframe the same as suspension?
A subframe is a structural component of a vehicle, such as an automobile or an aircraft, that uses a discrete, separate structure within a larger body-on-frame or unit body to carry certain components, such as the engine, drivetrain, or suspension. The subframe is bolted and/or welded to the vehicle.
What does a rear lower tie bar do?
The lower tie bar is designed to reduce the non-pivoting movement of the control arms and to stiffen the subframe to lessen the distortion of the lower suspension, especially during hard cornering. As a result, it improves the handling and steering response of the vehicle.
Are EG and DC subframe the same?
The subframes themselves are the same. As well as the mounting points to the steering rack where the rack/pinion is are the same. The only difference between the two is the welded bracket on the passenger side where the clamp is — because a power steering rack is bigger in diameter than a non-power steering rack.
Is a subframe a highly stressed component?
It a subframe which is classed as a “Highly stressed component” so different rules apply. Not shooting you down at all.
Why do cars have subframes?
The purpose of using a subframe in an automobile is to distribute high local loads over a wider area of the body structure (most relevant in thin-walled monocoque body designs) and to isolate vibration and harshness from the rest of the body. The subframes are bolted or welded to the vehicle body.